On the WLSE, which of the following fault policies would be used to verify that access to thecommand-line interface of the access point is secure?()
第1题:
A.WLSEsupportscentralizedconfiguration.
B.WLSEsupportsdistributedconfiguration.
C.WLSEcanpickupstatisticsonadeviceevenifthedeviceisnotproperlyconfigured.
D.WLSEcanbeusedtoupgradethefirmwareonAPsandbridges.
E.WLSEmonitorsdevicefaultandperformanceconditionsbutcannotreportanypolicymisconfigurations
第2题:
A.WCS
B.WLSE
C.LocationAppliance
D.WDS
E.WLSE-Express
第3题:
A.configurationofAPs
B.autodiscoveryofrogueAPs
C.reporting
D.WLSEintwoversions:baseandlocation
E.graphicalviewofmultiplecontrollersandmanagedAPs
第4题:
Which two statements regarding the Wireless LAN Solution Engine (WLSE) are true? ()
第5题:
Which two statements about the WLAN Solution Engine (WLSE) are true?()
第6题:
On the WLSE or WLSE Express, which of the following criteria for applying automanaged configurations can be combined?()
第7题:
On the wlse, radio management must be enabled to use most of the features of which one of the following?()
第8题:
When using the WLSE to verify RF coverage, which task will use the configured radio settings?()
第9题:
To support fault and policy reporting, the WLSE requires a Wireless Control System (WCS).
When WLSE detects an AP failure, it automatically increases the power and cell coverage of nearby APs.
WLSE requires the 2700 location appliance to offer location tracking.
WLSE can locate rogue APs and automatically shut them down.
WLSE configuration is done using the command line interface (CLI) or a WEB based template.
第10题:
CiscoWorks Wireless LAN Solution Engine (WLSE)
CiscoWorks Wireless LAN Solution Engine (WLSE) Express
Cisco Wireless Control System (WCS)
Wireless Domain Services (WDS)
WLAN Controllers (WLC)
第11题:
To support fault and policy reporting,the WLSE requires a Wireless Control System (WCS).
When WLSE detects an AP failure,it automatically increases the power and cell coverage of nearbyAPs.
WLSE requires the 2700 location appliance to offer location tracking.
WLSE can locate rogue APs and automatically shut them down.
WLSE configuration is done using the command line interface (CLI) or a WEB based template.
第12题:
registration error
authentication failures threshold
HTTP disabled
Telnet disabled
第13题:
A.AnautonomouswirelesssolutionincludeslightweightAPsandWLANcontrollers.TheAPsandtheWLANcontrollersaremanagedbyaWLANsolutionengine(WLSE/WLSM).
B.AnautonomouswirelesssolutionincludeslightweightAPsandWLANcontrollers.TheAPsandtheWLANcontrollersaremanagedbytheCiscoWirelessControlSystem(WCS).
C.AlightweightwirelesssolutionincludeslightweightAPsandWLANcontrollers.TheAPsandtheWLANcontrollersaremanagedbyaWLANsolutionengine(WLSE/WLSM).
D.Alightweightwirelesssolutionconsistsofautonomousaccesspoints(APs),whicharemanagedbyaWLANsolutionengine(WLSE/WLSM).
E.AlightweightwirelesssolutionincludeslightweightAPsandWLANcontrollers.TheAPsandtheWLANcontrollersaremanagedbytheCiscoWirelessControlSystem(WCS).
第14题:
A.WLANcontrollers
B.WLANSolutionEngine(WLSE)
C.CiscoWirelessControlSystem(WCS)
D.CiscoWirelessLocationAppliance
E.lightweightaccesspoint(AP)
F.autonomousaccesspoint(AP)
第15题:
What management tool could be used to provide centralized configuration, monitoring, and management in a network built on Cisco wireless LAN controllers and Lightweight APs? ()
第16题:
Which two statements regarding the Wireless LAN Solution Engine (WLSE) are true?()
第17题:
You are conducting a cdp-based discovery using an edge switch for the seed. there is a router between the switch and the wlse. none of the access points are discovered, and the discovery log shows the switch is snmp unreachable. What is the problem?()
第18题:
Which two statements regarding the Wireless LAN Solution Engine (WLSE) are true ?()
第19题:
There are 30 managed access points on the wlse. a radio scan is started but fails. Upon inspection of the device list in the reports tab, you notice a red indicator on the wds access point. upon inspection of the wds access point through its guid, it is discovered that the security keys are not set up between the wds access point and the wlse. Which of the following is mis configured?()
第20题:
Which two features are supported by the WLAN Solution Engine (WLSE)?()
第21题:
An autonomous wireless solution includes lightweight APs and WLAN controllers. The APs and the WLAN controllers are managed by a WLAN solution engine (WLSE/WLSM).
An autonomous wireless solution includes lightweight APs and WLAN controllers. The APs and the WLAN controllers are managed by the Cisco Wireless Control System (WCS).
A lightweight wireless solution includes lightweight APs and WLAN controllers. The APs and the WLAN controllers are managed by a WLAN solution engine (WLSE/WLSM).
A lightweight wireless solution consists of autonomous access points (APs), which are managed by a WLAN solution engine (WLSE/WLSM).
A lightweight wireless solution includes lightweight APs and WLAN controllers. The APs and the WLAN controllers are managed by the Cisco Wireless Control System (WCS).
第22题:
the snmp communities on the switch do not match the wlse.
the snmp communities on the access points do not match the wlse.
the snmp communities on the access points do not match the switch.
the snmp communities on the router do not match the wlse.
第23题:
to support fault and policy reporting, the WLSE requires a Wireless Control System (WCS)
when WLSE detects an AP failure, it automatically increases the power and cell coverage of nearby APs
WLSE requires the 2700 location appliance to offer location tracking
WLSE can locate rogue APs and automatically shut them down
WLSE configuration is done using the command line interface (CLI) or a WEB based template
第24题:
shut down rogue access points
configure access points
discover access points
inventory access points