During normal cluster processing in a five-node cluster,one of the nodes unexpectedly crashes. A review of the system dump indicates that a DMS timeout has occurred. The cluster is configured to use disk heartbeats as a Point-to-Point network. What should be done to address the problem with this configuration?()
第1题:
When deploying IPCC Express 4.0 for the first time, when and where is the licensing of the customer specified? ()
第2题:
What is required during the initial creation of a cluster?()
第3题:
The first step documented in Company.com’s HACMP test plan is to start the cluster manager on the normal service node and verify that HACMP daemons have started with the ’lssrc -g cluster" command. What daemons MUST show as active in the ’lssrc -g cluster" command to have an operational cluster?()
第4题:
During an internal IT organization planning session, it is decided that a new cluster node would Enhance the performance of a distributed corporate application. Planning details have been assigned to the administrator. System outages are limited to one weekend per month; therefore, availability will be a key issue in the planning process. How much cluster downtime will need to be allocated for adding a new node?()
第5题:
allow greater than normal loads to be handled by the gear
act as an inboard guy in the event the inboard guy parts during cargo handling
assist the outboard guy in supporting stresses during cargo handling
prevent the inboard guy from parting due to stresses during cargo handling
第6题:
You should allow failback only during non-business hours
You should immediately allow failback
You should prevent automatic failback
You should allow failback only during business hours
第7题:
Stop the node.
Stop the cluster.
Run autodiscovery.
Configure the IP adapter.
第8题:
Remaining members recover by repartitioning the data across the remainig cluster members in parallel with normal request processing
Some latencies may be experienced due to higher priority of recovery
In flight operations may be lost
A system administrator must manually assist recovery of the lost data
第9题:
Completed, Deposited, Released, Shipped
Completed, Released, Shipped, Deposited
Deposited, Released, Shipped, Completed
Released, Shipped, Completed, Deposited
Released, Shipped, Deposited, Completed
第10题:
All cluster resources halt on Node ’B’,and one or both surviving nodes will gracefully acquire the resources.
All cluster processes halt on Node ’B’,the cluster resources remain active,and the remaining nodes take no action.
All cluster processes stay active on Node ’B’,cluster resources are halted,and the remaining nodes take no action.
All cluster resources will stop,cluster processes halt on Node ’B’,and the remaining cluster nodes take no action.
第11题:
clstrmgrES,clsmuxpdES
topsvcsd,grpsvcsd,exaixos
topsvcsd,grpsvcsd,clinfoES,grglsmd
clstrmgrES,clsmuxpdES,topsvcsd,grpsvcsd
第12题:
SAN switches
Fibre channel Hub(s)
IBM Storage Manager Agents
IBM Subsystem Device Driver
第13题:
During implementation of a two-node cluster,it is determined that error notification for the shared Disk subsystem would be beneficial. Which of the following is a pre-requisite for implementing automatic error notification?()
第14题:
An administrator has made several topology and resource group changes on one node in a running cluster.During verification and synchronization, using the "Emulate" option, many errors are reported. Theadministrator decided the best course of action was to roll back the changes. Prior to the changes beingmade, a cluster snapshot was taken. Which of the following actions will roll back the changes with the least disruption?()
第15题:
An enterprise has two nodes: -Node ’A’ runs a large relational database and ha six CPUs and 32GB of memory. -Node ’B’ is an application server with three CPU’s and 16GB of memory. During peak production periods, the CPU load for Node ’A’ is normally between 30% and 40%. For Node ’B’, the CPU load is 10% to 20% during peak production periods. Which of the following describes the best solution for an HACMP cluster?()
第16题:
During an HACMP migration,two nodes of a four-node cluster have been migrated. The existing hardware of the remaining two nodes do not meet the pre-requisites of the HACMP level that is being installed. Which of the following is the best method for resolving this issue?()
第17题:
Upgrade the unsupported hardware and continue with the migration.
Restore the two nodes that have been migrated with a cluster snapshot.
Restore the two nodes that have not been migrated with a cluster snapshot.
Synchronize the cluster to allow the nodes that didn’t migrate to join the cluster.
第18题:
clruncmd
clrestart
clcontinue
clresactive
第19题:
Use thee cascading resource groups where ’rg1’ and ’rg2’ fallover to Node ’B’ and ’rg3’ falls over to Node ’C’
Use Dynamic Node Priority resource groups with a priority chain consisting of Node ’A’ then Node ’B’ then Node ’C’
Use three rotating resource groups with ’rg1’ and ’rg2’ falling over to node ’B’ and ’rg3’ falling over to Node ’C’
Upgrade Nodes ’B’ and ’C’ to be equal to Node ’A in CPU and memory resources to enable the cluster to synchronize three resource groups
第20题:
Ignore the warning as synchronization completed successfully.
Populate the /usr/es/sbin/cluster/netmon.cf file with one or many IP addresses external to the cluster.
Create another virtual adapter on each node and set-up PowerHA networking in a more traditional fashion
Populate the /usr/es/sbin/cluster/netmon.cf file with any of the boot IP addresses on one of the othercluster nodes
第21题:
More disk should be added to the disk heartbeat network,allowing more paths for heartbeats.
An RS232 network is required to supply a more robust non-IP network when disk heartbeating is implemented.
The network tunable parameters should be changed to allow more missed heartbeats since the disks may be heavily used.
An error notification method is required to determine the action to take in response to a failure of the disk heartbeat.
第22题:
exhaust gas temperature system
exhaust load system
constant or pulse pressure system
constant volume system
第23题:
rg1 is configured with a delayed fallback timer
Settling time policy has not been configured for rg1
Node1 does not have sufficient resources to support rg1
Node2 is the first in the ’Default Node Priority’ list for resource group rg1
第24题:
Nothing,because HACMP will discover the configuration
The cluster name and a TCP/IP path to each of the nodes
The cluster name and ID and a TCP/IP path to each of the nodes
The cluster name and ID node names and a TCP/IP path to each of the nodes