encapsulation封装
第1题:
哪个命令用来设置Cisco设备串行接口的默认封装()
A.Router(config)encapsulation hdlc
B.Router(config)encapsulation default hdlc
C.Router(config-if)encapsulation hdlc
D.Router(config-if)encapsulation ppp
第2题:
You are bringing up a new Ezonexam switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method. When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?
A.Switch(config)# switchport trunk encapsulation isl
B.Switch(config)# switchport trunk encapsulation ietf
C.Switch(config-if)# switchport trunk encapsulation isl
D.Switch(config-if)# switchport trunk encapsulation ietf
E.Switch(config-if)# switchport trunk encapsulation dot1q
第3题:
A. Router(config-if)# encapsulation frame-relay q933a
B. Router(config-if)# encapsulation frame-relay ansi
C. Router(config-if)# encapsulation frame-relay ietf
D. Router(config-if)# encapsulation frame-relay isl
E. None of the above
第4题:
A.encapsulation hdlc
B.link-protocol hdlc
C.hdlc enable
D.link-protocolppp
第5题:
Cisco路由器串口默认是HDLC封装帧,使用()命令。
第6题:
为了实施X.25网络时,把Quidway路由器封装为dce,下列配置命令正确的是什么?()
第7题:
在华为路由器上的串行接口上封装PPP协议,需要在接口视图下输入的命令是( ).
第8题:
You are bringing up a new Cisco Catalyst switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method. When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?()
第9题:
第10题:
Switch(config-if)#switchport mode trunk isl
Switch(config-if)#switchport mode encapsulation isl
Switch(config-if)#switchport trunk encapsulation isl
Switch(config-if)#switchport mode trunk encapsulation isl
第11题:
TK1(config-if)# encapsulation hdlc ansi
TK1(config-if)# encapsulation ppp
TK1(config-if)# encapsulation LAPD
TK1(config-if)# encapsulation frame-relay ietf
TK1(config)#encapsulation ppp
第12题:
IETF
HDLC
Q9333-A Annex A
ANSI Annex D
第13题:
在华为路由器上的串行接口上封装PPP协议,需要在接口视图下输入的命令是()。
A.link-protocol ppp
B.encapsulation ppp-----cisco设备下使用
C.enable ppp
D.address ppp
第14题:
A. TK1(config-if)# encapsulation hdlc ansi
B. TK1(config-if)# encapsulation ppp
C. TK1(config-if)# encapsulation LAPD
D. TK1(config-if)# encapsulation frame-relay ietf
E. TK1(config)#encapsulation ppp
第15题:
A. IETF
B. HDLC
C. Q9333-A Annex A
D. ANSI Annex D
第16题:
包裹(encapsulation)
第17题:
在MSR路由器上将链路封装从PPP改为HDLC的命令是()
第18题:
VRP中,以下哪个命令用来配置路由器串行接口封装PPP协议?()
第19题:
You are preparing to create a point to point WAN by connecting a Cisco router with a Juniper router by way of their serial links. Which one of the following commands would you use?()
第20题:
VRP平台上,设置Serial接口数据链路层的封装类型为HDLC的命令是()。
第21题:
Gn
Gb
Gi
Gr
第22题:
第23题:
Router(config-if)# encapsulation frame-relay q933a
Router(config-if)# encapsulation frame-relay ansi
Router(config-if)# encapsulation frame-relay ietf
Router(config-if)# encapsulation frame-relay isl
None of the above