You issue this statement:ALTER DATABASE BACKUP CONTROLFILE TO TRACE; What does the statement generate?()
第1题:
A user is successfully authenticating to the network but is unable to access protected resources behind a ScreenOS enforcer. You log in to the ScreenOS enforcer and issue the command get auth table infranet and you do not see the user listed.Which two event log settings on the Junos Pulse Access Control Service must you enable to troubleshootthis issue?()
A. Connection Requests
B. System Errors
C. Enforcer Events
D. Enforcer Command Trace
第2题:
You are troubleshooting a problem with a cisco 7920 wireless ip phone that is causing the phone to drop calls. the problem appears to be a roaming bandwidth issuE. in order to verify what kind of issue it is, you decide to increase the bandwidth reserved for roaming on the wlan controller to the maximum. What level do you set the bandwidth to?()
第3题:
You delete a trace options file and later notice that no new entries are being written to this file. What would allow the entries to be written to the file again?()
第4题:
While troubleshooting a network connectivity issue, you suspect that a router may be missing a route, or may be receiving bad routing information to a destination. What command should you issue to view the route that the router will use to reach a given destination?()
第5题:
Your database is running in the ARCHIVELOG mode. You have configured RMAN for backup and recovery operations. You execute the following command from the RMAN prompt: RMAN> CONFIGURE CONTROLFILE AUTOBACKUP ON; After executing this command, in which of the following cases will RMAN make an auto-backup of the control file? ()
第6题:
You need to design a PKI that meets business requirements. What should you do?()
第7题:
You need to design a remote access strategy for portable computers. Your solution must meet business requirements. What should you do?()
第8题:
第9题:
The IP addresses are configured incorrectly.
Frame Relay LMI messages not displayed in real time.
The administrator must issue the enable frame-relay lmi debug command.
The administrator must issue the terminal monitor command.
Debug messages can only be received once through the console port.
The administrator must issue the show frame-relay lmi vty 0 4 command
第10题:
Issue the startup nomount command and then issue the restore parameter file command from the RMAN prompt.
Issue the startup nomount command and then issue the restore spfile command from the RMAN prompt.
Issue the startup nomount command and then issue the restore spfile from autobackup command from the RMAN prompt.
Issue the startup nomount command and then issue the restore spfile from backup command from the RMAN prompt.
Issue the restore spfile from autobackup command from the RMAN prompt.
第11题:
5 percent
15 percent
25 percent
35 percent
第12题:
Updating
Viewing
Deleting
Inserting
Truncating
第13题:
You have just issued the command commit confirmed and your network continues to be operational with no further changes required. You issue a commit and-quit. A short time later, users start complaining about network problems. Which commands (in order) need to be entered to resolve this issue?()
A.A
B.B
C.C
D.D
第14题:
You need to troubleshoot an issue on the switched LAN. When you issue a command "show port3/1" on a switch, you observe the Giants column has a non-zero entry. What could cause this?()
第15题:
A system administrator did not receive a response while attempting to ping loopback. Which of the following would most likely resolve this problem?()
第16题:
From SQL*Plus, you issue this SELECT statement: SELECT* FROM order; You use this statement to retrieve data from a data table for ().
第17题:
You discover an out-of-space condition in the database. You decide to suspend a session for five minutes. You issue the following command to suspend the session: ALTER SESSION ENABLE RESUMABLE; Which command could you issue to enable the resumable space allocation feature at the session level?()
第18题:
You are the Exchange administrator for your organization.You need to move a user’s mailbox from the mailbox server role of an Exchange 2007 SP2 server to the mailbox server role of an Exchange 2010 server in the same forest.You must ensure that the end-user can still access their e-mail account.What action should you take?()
第19题:
ping
trace
show ip route
show interface
show cdp neighbors
第20题:
IEEE 802.10
Misconfigured NIC
User configuration
IEEE 802.1Q
None of the other alternatives apply
第21题:
anticipate
participate
preserve
announce
第22题:
Connection Requests
System Errors
Enforcer Events
Enforcer Command Trace
第23题:
that
what
who
where
第24题:
when you change the name of a datafile
when you drop a table from the database
when you take an export of the database
when you back up the database using OS utilities
when you issue an ALTER SYSTEM SWITCH LOGFILE statement
when you issue a BACKUP command from inside the RMAN run block