the protocol used to determine the authentication method
the protocol used to identify the data in the Information field
the protocol used to carry the PPP frame
the protocol used to decode the FCS field
the protocol used to detect the number of padding bytes
第1题:
What does the "Inside Global" address represent in the configuration of NAT?()
第2题:
What does FRTP stand for?()
第3题:
ISL is being configured on a Company switch. Which of the following choices are true regarding the ISL protocol? ()
第4题:
What does the LSP Holdtime field in an IS-IS database indicate?()
第5题:
Which Ethernet field is used to differentiate between the FCoE frame and the FIP frame?()
第6题:
What protocol does an IP phone use to learn the voice VLAN ID it should use for voice traffic?()
第7题:
An authentication request for a PPP over ATM client has been returned to the router with an address of 255.255.255.254. What does this indicate to the router?()
第8题:
the protocol used to determine the authentication method
the protocol used to identify the data in the Information field
the protocol used to carry the PPP frame
the protocol used to decode the FCS field
the protocol used to detect the number of padding bytes
第9题:
A static IP address is used.
An unnumbered address is used.
The returned RADIUS address is used.
The IP address-pool configuration is used.
第10题:
LCP is used for basic PPP link setup and operation.
LCP is used for PPP CHAP authentication.
LCP is used for PPP over ATM (PPPoA) setup.
LCP is used for PPP over Ethernet (PPPoE) setup.
LCP is used for PPP over Frame Relay (PPPoFR) setup
第11题:
It can be used between Cisco and non-Cisco switch devices.
It calculates a new CRC field on top of the existing CRC field.
It adds 4 bytes of protocol-specific information to the original Ethernet frame.
It adds 30 bytes of protocol-specific information to the original Ethernet frame.
第12题:
Eliminates unburned fuel oil residues from the firebox
Increases boiler efficiency
Flushes away mineral deposits inside the water tubes
Cleans soot deposits from the inside of the stack
第13题:
When configuring a serial interface on a router, what is the default encapsulation?()
第14题:
What does the protocol field inside the PPP frame indicate?()
第15题:
When you display the routing table by entering the show route command, what does the* indicate?()
第16题:
Which statement about the Link Control Protocol (LCP) is true?()
第17题:
Which layer 2 protocol encapsulation type supports synchronous and asynchronous circuis and has built-in security mechanisms?()
第18题:
Which two of these are characteristics of the 802.1Q protocol?()
第19题:
The route is a direct route.
The route was selected as active.
The route is a default route.
The route was learned using a dynamic routing protocol.
第20题:
第21题:
Link Control Protocol(LCP) is used for basic PPP link setup and operation
Link Control Protocol(LCP) is used for denying PPP connections to unauthorized devices.
Link Control Protocol(LCP) for PPP is synonymous to ARP for Ethernet.
None of the above
第22题:
the LSP age
the LSP refresh interval
the LSP elapsed lifetime
the LSP remaining lifetime
第23题:
Ethernet FCS
Source address
Destination address
EtherType
Protocol type
第24题:
it is a layer 2 messaging protocol which maintains vlan configurations across network.
it includes an 8-bit field which specifies the priority of a frame.
it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
it is a trunking protocol capable of carring untagged frames.