The memory capacity requirements
The hardware product platform
The distribution channel
The feature capabilities
The run location and compression status
第1题:
CIS .com recently acquired a smaller competitor. The acquired company is not currently using Cisco routers, so you have connected the two WANs via an authenticated PPP link. After configuration both routers, issuing the show interface s0/0 command on the Cisco Router shows the interface to be in the up/down state.Which two of these are possible causes? ()
A. Bandwidth statements do not match
B. MTUs do not match
C. IP Addresses are not in the same subnet
D. CHAP passwords do not match
第2题:
A.show configuration
B.show environment
C.show inventory
D.show platform
E.show version
第3题:
Which command reveals the last method used to powercycle a router?()
第4题:
After issuing the "show version" command on your Cisco router, you notice that the image is named "C7200-ajs40-mx". What does the C7200 portion of the filename represent?()
第5题:
Which Cisco IOS command displays the export VPN route target value of a VRF?()
第6题:
Which command will display the contents of the forwarding table?()
第7题:
Which command will display the contents of the forwarding table?()
第8题:
Which JUNOS software show command allows you to view BGP attributes for a given route?()
第9题:
You are logged into a router and with to view the layer 3 information about your neighboring Cisco routers. What IOS command gives layer 3 information for of the directly connected router interfaces?()
第10题:
Which command shows system hardware and software version information?()
第11题:
Which command will display only direct routes?()
第12题:
The Cisco IOS image file will not be visible in the output from the show flash command.
The show version command will not show the Cisco IOS image file location.
When the router boots up, the Cisco IOS image will be loaded from a secured FTP location.
The running Cisco IOS image will be encrypted and then automatically backed up to a TFTP server.
第13题:
A.show protocols
B.show process
C.show system
D.show version
第14题:
查看Cisco7600IOS版本信息的命令是()。
第15题:
Which command reveals the last method used to power cycle a router?()
第16题:
CIS .com recently acquired a smaller competitor. The acquired company is not currently using Cisco routers, so you have connected the two WANs via an authenticated PPP link. After configuration both routers, issuing the show interface s0/0 command on the Cisco Router shows the interface to be in the up/down state. Which two of these are possible causes? ()
第17题:
After the site installation is complete, you should verify the mobility of the VoWLAN device whilewalking the site on an active phone call. Which Cisco WLC or Cisco WCS command is mostbeneficial in determining roaming efficiency?()
第18题:
Which command will show the best paths that are installed in the PFE?()
第19题:
Which command displays the egress interfaces selected on the PFE for destination prefixes?()
第20题:
Which command can you use to determine the cisco ios feature set on a cisco router?()
第21题:
Which command displays CPU utilization?()
第22题:
Which command allows viewing of only OSPF routes?()
第23题:
Which JUNOS software show command allows you to view BGP attributes for a given route?()