The supporting documentation
The vendor website
The Internet
The server event logs
第1题:
An administrator has added an additional network adapter to each cluster node. The adapters have been configured and tested, and the /etc/hosts file has been updated. However,the adapters do not appear in the pick list when the administrator tries to define the adapters to HACMP. What would be required to correct this problem?()
第2题:
An administrator is troubleshooting a problem on an application server, but has not determined the cause of the problem and is not able to replicate the problem. Which of the following should the administrator do prior to escalating the issue?()
第3题:
Which of the following are the FIRST actions to take when an administrator is troubleshooting aserver?()
第4题:
The server administrator has just brought a new Windows server online. Permissions are set, but the server administrator cannot connect remotely. Which of the following is MOST likely the problem?()
第5题:
An administrator has a server experiencing performance problems with logical volumes within a particular volume group. Which command can report I/O statistics for logical partitions with each logicalvolume within the volume group()
第6题:
A system administrator is monitoring a system that has recently shown a decrease in performance.The administrator suspects that the system may be low on memory and may be paging excessively.Which of the following commands is best to identify a possible paging problem?()
第7题:
Battery needs to be replaced
Light switch is turned off
Smart cable is disconnected
UPS needs a firmware update
第8题:
lslv
lsvg
iostat
lvmstat
第9题:
Gather information from users.
Reboot the server.
Apply the latest service packs to the operating system.
Perform a root cause analysis
第10题:
Gather information from users.
Reboot the server.
Apply the latest service packs to the operating system.
Perform a root cause analysis.
第11题:
Make one change at a time and test/confirm the change has resolved the problem.
Verify full system functionality.
Replicate the problem.
Determine if a common element is causing multiple problems.
Identify any changes to the server.
第12题:
The supporting documentation
The vendors website
The Internet
The servers event logs
第13题:
An administrator has encountered a problem with a particular piece of software installed on the server and begins the troubleshooting process. Which of the following is the FIRST place the administrator should look for specific information about the problem?()
第14题:
An administrator has a malfunctioning uninterruptible power supply (UPS). Which of the following is the MOST likely cause of the problem?()
第15题:
An administrator notices that every time a particular server is restarted it requires a password in order for the server to begin the start up process. Which of the following is the reason this is happening?()
第16题:
An administrator has shut down a server to install additional memory. When the administrator restarts the server after the upgrade, it times out. Which of the following could be the cause of the problem?()
第17题:
An administrator has mirrored the root volume group to a second disk, but ’bootlist’ is failing to correctly add the second disk. What is the likely cause of the problem?()
第18题:
A system administrator has just applied an update to an AIX system to correct a problem, The APAR number is IX49035 and was shipped as part of the PTF number U437542. After applying the APAR fix, the administrator wants to ensure that the fix is applied before informing the system users of the corrected problem. Which of the following commands should the system administrator run to verify that the APAR fix has been applied to the system?()
第19题:
retrieval
adjusting tension
excessive strain
hookup to main towline
第20题:
Processor failure
Third party memory
Disk drive failure
ESD during the upgrade
Backplane failure
第21题:
Cloning
Bare Metal Restore
OS Restore
Snapshot
第22题:
The server needs to have the password service verified and reconfigured.
The server administrator has set a password policy in Group Policy.
The server has the BIOS setting configured incorrectly.
The server is set with a boot password before accessing the OS
第23题:
The administrator has failed to run ’bosboot -ad <2nd disk>’ prior to the bootlist command.
The administrator has failed to run ’bootinfo -B <2nd disk>’ prior to the bootlist command.
The administrator has failed to run ’mirrorvg -m rootvg <2nd disk>’ prior to the bootlist command.
The administrator has failed to run ’bosboot -ad /dev/ipldevice <2nd disk>’ prior to the bootlist command.
第24题:
The supporting documentation
The vendor website
The Internet
The server event logs