The named is not running
The default gateway is not set
The NIS master server is down
Ipforwarding is not turned on
第1题:
Refer to the exhibit.HostA cannot ping HostB.Assuming routing is properly configured,what could be the cause of this problem?()
第2题:
To examine the Exhibit, press the Exhibit button. Which of the following addresses should be reachable without adding any routes?()
第3题:
To examine the Exhibit, press the Exhibit button. Which of the following addresses will be reachable without adding any routes?()
第4题:
You have two servers named Server1 and Server2 that run Windows Server 2003 Service Pack 2 (SP2). The IP configuration for Server1 is shown in the Server1 IP exhibit. (Click the Exhibit button.) The IP configuration for Server2 is shown in the Server2 IP exhibit. (Click the Exhibit button.) Server1 is unable to contact Server2. You need to ensure that Server1 can contact Server2. What should you do?()
第5题:
Increase the number of nfsd's on the client.
Increase the number of biod's on the client.
Decrease the number of nfsd's on the server.
Increase the size of nfs_socketsize on the server.
第6题:
FTP
SSH
Telnet
J-Web
第7题:
129.35.54.21
129.35.57.21
129.35.58.21
129.35.55.21
第8题:
The named is not running
The default gateway is not set
The NIS master server is down
Ipforwarding is not turned on
第9题:
errpt -t
errpt -a
errpt -D
errpt
第10题:
120M
320M
480M
600M
第11题:
HostA is not on the same subnet as its default gateway
The address of SwitchA is a subnet address
The Fa0/0 interface on RouterA is on a subnet that cannot be used
The serial interfaces of the routers are not on the same subnet
The Fa0/0 interface on RouterB is using a broadcast address
第12题:
Three physical interfaces are redundant.
You must define an additional Redundancy Group.
node 0 will immediately become primary in the cluster.
You must issue an operational command and reboot the system for the above configuration to take effect.
第13题:
When an ICMP redirect is received, which of the following options is the most appropriate to conclude?()
第14题:
To examine the Exhibit, press the Exhibit button. The system administrator notices a system with routing cannot communicate with a system with an ip address 192.24.34.6. Using the information provided in the exhibit, what is the most likely reason?()
第15题:
Examine the exhibit to view the parameters set in your parameter file. (Click the Exhibit(s) button.) You restart the instance. To what value will the MEMORY_MAX_TARGET parameter be set by default?()
第16题:
You have a server that runs Windows Server 2003 Service Pack 2 (SP2). The server connects to the Internet by using a router.You attempt to launch Windows Update and receive the following error message: “Cannot find server or DNS Error.”The IP configurations of the server are shown in the exhibit. (Click the Exhibit button.)ou need to ensure that the server can connect to Windows Update. What should you do?()
第17题:
On Server2, modify the subnet mask.
On Server1, modify the DNS server address.
On Server2, change the node type to broadcast.
On Server1, configure a static IP address for the Local Area Connection.
第18题:
12:28am on May 25,1999
12:28pm on May 25,1999
5:25am on December 28,1999
5:25pm on December 28,1999
第19题:
lsps
tprof
iostat
vmtune
第20题:
0.947 Mbps
3.000 Mbps
4.065 Mbps
282.058 Mbps
第21题:
Line 26 prints "a" to System.out.
Line 26 prints "b" to System.out.
An exception is thrown at line 26 at runtime.
Compilation of class A will fail due to an error in line 6.
第22题:
Compilation of class A fails.
Line 28 prints the value 3 to System.out.
Line 28 prints the value 1 to System.out.
A runtime error occurs when line 25 executes.
Compilation fails because of an error on line 28.
第23题:
Configure the server to have static IP settings.
Install the DNS Server service on Server1 and configure DNS to use a forwarder.
Add an entry to the %systemroot%/system32/drivers/etc/hosts file for update.microsoft.com.
Add an entry to the %systemroot%/system32/drivers/etc/lmhosts file for update.microsoft.com.
第24题:
This is a uniprocessor system
The "prog" process has a nice value of 107
There are two active processors on this system
The "prog" process will only be scheduled to run on processor 0