netstat -in
ifconfig -a
arp -a
cfgmgr
第1题:
After rebuilding the list of virtual devices used by the VIO server using the "cfgdev" command, which command would be run to verify that a newly configured virtual SCSI adapter is available?()
第2题:
After making changes to IP aliasing and rebooting the system, an AIX server is unable to communicate with other hosts. Which command can be run to check ent0 adapter configuration relative to IP address and network mask?()
第3题:
Users complain they cannot communicate with a server. The system administrator suspects there may be a problem with the Ethernet adapter or with the way it is configured. Which command can be run to verify the adapter is configured correctly?()
第4题:
A system administrator is monitoring a system that has recently shown a decrease in performance.The administrator suspects that the system may be low on memory and may be paging excessively.Which of the following commands is best to identify a possible paging problem?()
第5题:
An administrator is supporting an AIX 6.1 LPAR remotely and needs a tape operator to plug a cable into an Ethernet adapter. The tape operator does not have POWER6 595 knowledge. What can the administrator do to assist the tape operator to locate the correct adapter?()
第6题:
Run cfgdev on the VIO server and re-run the mkvdev command.
Run chdev -a sea_enable=yes on the physical Ethernet adapter.
Remove and re-add the virtual Ethernet adapter.
Remove the IP address from the physical adapter and re-run the mkvdev command.
第7题:
The SCSI card is not seated correctly.
The termination is incorrectly set on the SCSI card.
The SCSI card is not listed on the operating system HCL (Hardware Compatibility List).
Operating system patches were not updated before installing the card.
第8题:
A virtual Ethernet adapter can only connect to other partitions within the same system.
A virtual Ethernet adapter needs to be connected to an external VLAN capable switch to be able to communicate with other partitions on the same system.
A partition can support an unlimited number of virtual Ethernet devices.
A virtual Ethernet adapter in the VIO Server that is part of a SEA should not have the trunk flag set
第9题:
Default gateway
The ports on the switch
Port security on the servers switch port
Ethernet cable
第10题:
ping
netstat
nbtstat
telnet
第11题:
iostat
netstat
ps
vmstat
第12题:
tar
tctl
tcopy
restore
第13题:
Which command can a system administrator use to verify that a tape is in backup format and is readable by the system?()
第14题:
An administrator issued a command to update thefirmware of an Ethernet adapter on a partitioned system, but received an error. What is the most likely cause of the problem?()
第15题:
A system administrator is monitoring a system that has recently shown a decrease in performance. The administrator suspects there is an overload of traffic on a single Ethernet adapter. Which of the following commands is best to identify a possible overload of the Ethernet adapter?()
第16题:
Company.com has a VIO server with a configured virtual Ethernet adapter and a physical Ethernet adapter with an IP address on their local public network. They want to re-configure the physical Ethernet adapter as Shared Ethernet Adapter. When the mkvdev command is run, the following method error is returned: /usr/lib/methods/cfgsea . Which of the following will most likely resolve the problem?()
第17题:
lsdev -virtual
lsdev -Cs scsi
lscfg -vl
lsdev -adapter
第18题:
installp
lslpp
lppchk
oslevel
第19题:
ifconfig -a
errpt -a
cfgmgr -v
entstat -d ent0
第20题:
ping
iostat
netstat
ifconfig
第21题:
The adapter must be taken offline prior to the firmware update.
The system has not been rebooted since the adapter was added to the LPAR.
The adapter must be assigned to the service partition prior to updating the firmware.
The adapter must be dynamically removed from the LPAR prior to updating thefirmware.
第22题:
Advise the tape operator to review the hardware service guide.
Use the diag command to set the Ethernet adapter slot LED to flash.
Advise the tape operator to check the WWN stickers of all Ethernet adapter in the I/O drawers.
Create a login account for tape operator on the HMC and advise the tape operator to locate the adapter using the GUI step by step.
第23题:
entO is in a defined state
enO is currently active
There is no physical network adapter on the system
The address 172.168.0.50 is in use by another system
第24题:
netstat -in
ifconfig -a
arp -a
cfgmgr