ip host routes
ip access-routes
host routes enabled
access-routes enabled
第1题:
Which three of the following protocols will be forwarded to a host specified by the ip helper - address interface configuration command if the configuration has not been modified by the ip forward - protocol udp global con figuration command?()
A. BOOTP
B. TFTP
C. ARP
D. DNS
E. proxy - ARP
F. FTP
第2题:
The command "ip route 192.168.24.64 255.255.255.192 192.168.8.2 100" was configured on a router named TK1. No routing protocols or other static routes are configured on the Corporate router yet.Based on this information, which statement is true about this command?()
A. This command sets a gateway of last resort for the TK1 router.
B. The number 100 indicates the number of hops to the destination network.
C. The interface with IP address 192.168.8.2 is on the TK1 router.
D. The command creates a static route for all IP traffic with the source address 192.168.24.64.
E. Packets destined for host 192.168.24.124 will be sent to 192.168.8.2.
F. None of the above
第3题:
Which information will the Cisco IOS command show ip ospf rib display?()
第4题:
Which profile configuration command dynamically creates a host route in the routing table?()
第5题:
In a PPP over ATM service offering,which command inserts the user's host route into the routing table?()
第6题:
When configuring an interface using SMIT and Further Configuration with an IP address and netmask, which of the following outcomes indicates how the routing tables will be affected?()
第7题:
You are required to configure a SCREEN option that enables IP source route option detection.Which twoconfigurations meet this requirement?() (Choose two.)
第8题:
To dynamically assign host routes on an LNS,where should the ip access-routes command be applied?()
第9题:
show ip ospf route
show ip route protocol ospf
show route protocol ospf
show ospf table
第10题:
It statically places a host route in the routing table.
It statically associates an IP address with a customer.
It dynamically creates a host route in the routing table.
It dynamically assigns an address to the router's interface
第11题:
profile
remote host
aaadomain-map
l2tp destination profile
第12题:
BOOTP
TFTP
ARP
DNS
proxy - ARP
FTP
第13题:
Refer to the exhibit. A partial routing configuration is shown. Complete the configuration so that only the default - network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly? ()
A. access - list 100 permit ip 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0 .0
B. access - list 100 permit ip host 0.0.0.0 any
C. access - list 100 permit ip any host 0.0.0.0
D. A default -network cannot be redistributed between routing processes.
第14题:
Which configuration command assigns a host route to the CPE workstation address of 192.168.10.1 in a Bridged 1483 network?()
第15题:
Which three of the following protocols will be forwarded to a host specified by the ip helper - address interface configuration command if the configuration has not been modified by the ip forward - protocol udp global con figuration command?()
第16题:
What does the ip access-routes configuration command accomplish?()
第17题:
You would like to configure your PC's IP address of 10.10.0.156 as an FTP host with a username of user and a password of mypass.Which configuration command accomplishes this goal?()
第18题:
The sysdumpdev command can be used to configure remote dump devices. Which of the following conditions is NOT used for a remote dump device configuration?()
第19题:
You would like to configure your PC’s IP address of 10.10.0.156 as an FTP host with au ser name of user anda password of mypass.Which configuration command accomplishes this goal?()
第20题:
This command sets a gateway of last resort for the TK1 router.
The number 100 indicates the number of hops to the destination network.
The interface with IP address 192.168.8.2 is on the TK1 router.
The command creates a static route for all IP traffic with the source address 192.168.24.64.
Packets destined for host 192.168.24.124 will be sent to 192.168.8.2.
None of the above
第21题:
The local and the remote host must have Transmission Control Protocol/Internet Protocol (TCP/IP) installed and configured.
The remote host must support NFS.
The remote host must have an NFS exported directory defined such that the local host has read and write permissions to the dump file on the remote host.
The remote host can be the same as the local host.
第22题:
ip host-route
ip access-routes
ip dynamic host-route
ip route access-routes
第23题:
ip host routes
ip access-routes
host routes enabled
access-routes enabled
第24题:
A subnet route is automatically added
A default route is automatically added
All other routes are automatically added
The routing table is not affected