config
clientqos.cnf
startup-config
running-configuration
第1题:
A.FTP
B.SNMPv2
C.TFTP
D.KTTPS
第2题:
A.No configuration file was found in NVRAM.
B.No configuration file was found in flash.
C.No configuration file was found in the PCMCIA card.
D.Configuration file is normal and will load in 15 seconds.
第3题:
Which BGP command provides the router ID, local preference, next hop, and BGP path in its output?()
第4题:
There are no boot system commands in a router configuration in NVRAM.What is the fallback sequencethat router will use to find an ios during reload?()
第5题:
A cisco router is booting and has just completed the POST process.It is now ready to find and load an IOS image.what function does the router perform next?()
第6题:
There are no boot system commands in a router configuration in NVRAM.What is the fall back sequence that router will use to find an ios during reload?()
第7题:
It checks the configuration register
It attempts to boot from a TFTP server
It loads the first image file in flash memory
It inspects the configuration file in NVRAM for boot instructions
第8题:
10.1.1.2
10.154.154.1
172.16.5.1
192.168.5.3
第9题:
FTP
SNMPv2
TFTP
KTTPS
第10题:
user@router# system delete configuration rescue
user@router> request system configuration rescue delete
user@router# delete rescue configuration
user@router> file delete rescue-configuration
第11题:
Because of damaged flash memory, the router will fail the POST
It will attempt to locate the IOS from a TFTP server. If this fails, it will initiate the setup dialog.
It will attempt to locate the IOS from a TFTP server. If this fails, it will load a limited IOS from ROM
It will attempt to locate the configuration file from a TFTP server. If this fails, it will initiate the setup dialog.
It will attempt to locate the configuration file from a TFTP server. If this fails, it will load a limited configuration from ROM
第12题:
Flash,TFTPserver,ROM
Flash,NVRAM,ROM
ROM,NVRAM,TFTPserver
NVRAM,TFTPserver,ROM
TFTPserver,Flash,NVRAM
第13题:
A. The router will not accept connections from the peer.
B. BGP can exchange routing information in this state.
C. The router is listening on its server port for connection requests from the peer.
D. The router ha s sent out an active TCP connection request to the peer.
第14题:
During startup, the router displays the following error message: boot: cannot open "flash:" What will the router do next?()
第15题:
Which of the following commands will display the name of the IOS image file being used in a Cisco router?()
第16题:
A cisco router is booting and has just completed the POST process.It is now ready to find and load an IOSimage.what function does the router perform next?()
第17题:
Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true?()
第18题:
Which command will delete the current rescue configuration?()
第19题:
The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2
The configuration is invalid because the DHCP options are global configuration commands
The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfaces
The router will choose which pool to use based upon the interface the DHCP request wasreceived on
第20题:
show ip route bgp
show ip bgp
show ip bgp neighbors
show ip bgp summary
第21题:
The router will use path1 when it is available and stable.
The router will use path3 when it is available and stable.
The router will attempt to establish path2 only when path1 and path3 are down.
The router will attempt to establish path1 only when path2 and path3 are down.
第22题:
The output describes the contents of a Type 5 LSA
3.3.3.3 identifies a ro uter as being the router performing redistribution
R1's metric for its best route to reach the router with RID 9.9.9.9 is 100
The router with RID 3.3.3.3's metric for its best route to reach the router with RID 9.9.9.9 is 100
第23题:
TFTP server, Flash, NVRAM
ROM, NVRAM, TFTP server
NVRAM, TFTP server, ROM
Flash, TFTP server, ROM
Flash, NVRAM, ROM