It occurs every 29 hours.
Packet interception mode is enabled.
The host is unreachable on the local subnet.
The subnet is unreachable using the advertised router.
第1题:
What are two instances when a WX device route carves? ()(Choose two.)
第2题:
Which two statements are true when source/destination filters are enabled? ()(Choose two.)
第3题:
Which two methods are used to assign an IP address to a WX device? ()(Choose two.)
第4题:
Which two types of optimization does the WX 60 device perform when Exchange 2003 and Outlook 2003 areused in the network? ()(Choose two.)
第5题:
Define application type.
Enable AppFlow for the application.
Enable monitoring for the application.
Define source and destination IP addresses.
第6题:
Admin > Device
Device Setup > Topology
Compression > Endpoints
Device Setup > Advanced > Topology
第7题:
Quality of service must be enabled.
NSC compression must be enabled.
PFA's TCP Acceleration (AFP) must be enabled.
AppFlow must be configured on the client-side device first
第8题:
SSH
Telnet
WebView
device front panel
serial console (command-line interface)
第9题:
Packet Flow Acceleration
Network Sequence Caching
AppFlow's MAPI acceleration
Molecular Sequence Reduction
第10题:
It protects signals against node failures between rings.
It protects signals against node failure within a single ring.
It allows for traffic to be preempted when a ring switch occurs.
Traffic can be dropped and continued at interconnecting nodes.
It protects preemptible traffic from being dropped when a ring switch occurs.
第11题:
Traffic needs be compressed.
Quality of service must be enabled.
A service tunnel must exist in at least one direction.
PFA must be enabled on the client-side WX device.
第12题:
Route reflectors are not passing updates properly.
BGP synchronization has been enabled.
The next-hop address is unreachable.
No loopback interface has been configured on a router.
第13题:
Which three packet interception methods are configurable in WX devices?() (Choose three.)
第14题:
What are two ways to verify if a WX device is configured as a hub, a spoke, or a mesh device? ()(Choose two.)
第15题:
What are two requirements when using AppFlow? ()(Choose two.)
第16题:
What are two merits of having a correct time setting on each WX/WXC device in a community? ()(Choose two.)
第17题:
It occurs every 29 hours.
Packet interception mode is enabled.
The host is unreachable on the local subnet.
The subnet is unreachable using the advertised router.
第18题:
Quality of service must be enabled.
NSC compression must be enabled.
PFA's TCP Acceleration (AFP) must be enabled.
AppFlow must be configured on the client-side device first.
第19题:
LAN
QoS
traffic
IPSec
第20题:
Use the CLI and enter show log.
Use the CLI and enter show all.
Use the CLI and enter show logging.
In WebView, choose Admin > Tools > Display System Log.
第21题:
Excluded traffic is not accelerated.
Excluded traffic is only compressed.
Source/destination filter applies to all traffic sent from LAN to WAN.
Source/destination filters work in packet interception mode using RIPv2.
第22题:
cabling
community topology
requires a license key
requires two IP addresses
registration server designation
第23题:
It can reduce routing table size.
It allows for optimal route selection.
It can reduce the number of routing updates.
It always shortens the attribute list for the aggregated route.
第24题:
Ensures connectivity to the registration server.
Allows WX devices to synchronize with one another.
Helps in the maintenance of WX devices using WX CMS.
Generates accurate and consistent monitoring reports.