A.No configuration file was found in NVRAM.
B.No configuration file was found in flash.
C.No configuration file was found in the PCMCIA card.
D.Configuration file is normal and will load in 15 seconds.
第1题:
A. the serial 1/1 address
B. the serial 2/0 address
C. a randomly generated internal address
D. the configured router - id address
第2题:
A.The router is in area 49.0001.0002
B.The router acts as a Level 1 - 2 router
C.CLNS routing is enable d for the router
D.The router has a system ID of 0003.0004
E.The interfaces have a functional IS - IS configuration
F.The network service access point selector (NSEL) byte has a value of 0
第3题:
A. 10.1.1.2
B. 192.168.1.49
C. 10.1.1.1
D. 192.168.1.50
第4题:
A.Router R1 is waiting for a reply from the neighbor 10.1.2.1 to the hello message sent out inquiring for a second successor to network 10.6.1.0/24
B.Router R1 can send traffic destined for network 10.6.1.0/24 out of interface FastEthernet0/0
C.Router R1 is waiting for a reply from the neighbor 10.1.2.1 to the hello message sent out before it declares the neighbor unreachable
D.Router R1 is waiting for a reply from the neighbor 10.1.2.1 in response to the query sent out about network 10 .6.1.0/24
第5题:
Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?()
A.The design will function as intended
B.Spanning-tree will need to be used.
C.The router will not accept the addressing scheme.
D.The connection between switches should be a trunk.
E.The router interfaces must be encapsulated with the 802.1Q protocol.
第6题:
A.Themaximumnumberofbytesthatcantraversethisinterfacepersecondis1500.
B.Theminimumsegmentsizethatcantraversethisinterfaceis1500bytes.
C.Theminimumpacketsizethatcantraversethisinterfaceis1500bytes.
D.Themaximumpacketsizethatcantraversethisinterfaceis1500bytes.
E.Themaximumframesizethatcantraversethisinterfaceis1500bytes.
第7题:
What can be determined from the line of show ip route output shown in the exhibit?()
第8题:
Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? ()
第9题:
10.1.1.2
10.154.154.1
172.16.5.1
192.168.5.3
第10题:
The design will function as intended
Spanning-tree will need to be used.
The router will not accept the addressing scheme.
The connection between switches should be a trunk.
The router interfaces must be encapsulated with the 802.1Q protocol.
第11题:
The degree of pain being suffered
The degree of vision impairment
Whether or not the brain is functioning properly
Whether or not the victim's blood pressure is normal
第12题:
Router ACLs can be applied to the input and output directions of a VLAN interface.
Bridged ACLs can be applied to the input and output directions of a VLAN interface.
Only router ACLs can be applied to a VLAN interface.
VLAN maps and router ACLs can be used in combination.
VLAN maps can be applied to a VLAN interface
第13题:
A. Additional DHCP options will be imported from another DHCP server.
B. The DHCP server pools need to be bound to an interface to operate.
C. This configuration will provide IP configuration information to two different su bnets.
D. Additional DCHP option information needs to be imported from another DHCP server.
E. If the router hands out all the addresses in pool 1, then it will supply addresses from pool 2.
第14题:
A. The router sent an IGMP version 2 query out interface Ethernet1 at multicast address 224.0.0.1.
B. Router RTA received an IGMP report version 1 from host 192.168.9.1.
C. Reverse Path Forwarding (RPF) is ena bled for 192.168.9.4.
D. Reverse Path Forwarding (RPF) is enabled for 224.0.1.40.
E. The IP multicast groups are 224.0.0.1, 224.0.1.40, and 239.255.0.1.
F. IP PIM RP mapping is static.
第15题:
A. the number of consecutive TCP connections to the specified remote neig hbor
B. the number of total TCP connections that the router has
C. the number of times the router has established a TCP connection
D. the number of neighbors that the router has
第16题:
A.The loopback addresses are on different subnets
B.The value of the dead timers on the router are different
C.Route summarization is enabled on both routers
D.The process indentifier on router A is different than the process identifier on router B
第17题:
A.Router1 has specific boot system command that instruct it to load IOS from TFTP server.
B.Router1 is acting as a TFTP server for other routers.
C.Router1 cannot locate a valid IOS image in flash memory.
D.Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
E.Cisco routers will first attempt to load a image from TFTP for management purposes.
第18题:
A.Packet is destined for a local interface to the router.
B.Packet was translated, but no response was received from the distant device.
C.Packet was not translated, because no additional ports are available.
D.Packet was translated and fast switched to the destination.
第19题:
What is true about access control on bridged and routed VLAN traffic? ()
第20题:
What is true about access control on bridged and routed VLAN traffic?()
第21题:
Router ACLs can be applied to the input and output directions of a VLAN interface
Bridged ACLs can be applied to the input and output directions of a VLAN interface
Only router ACLs can be applied to a VLAN interface
VLAN maps and router ACLs can be used in combination
VLAN maps can be applied to a VLAN interfac
第22题:
The next routing update can be expected in 35 seconds.
The IP address 10.10.10.6 is configured on S0/1.
The IP address 10.10.10.8 is configured on S0/1.
This route is using the default administrative distance.
The 10.10.10.8 network is two hops away from this router.
第23题:
The route is learne d from an eBGP peer
The route has no more than three ASNs in the AS_PatH
The route is the best route for this prefix
None of these facts can be positively determined by this output