A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?()
A. one
B. three
C. two
D. zero
第1题:
Which statements concerning the switch construct are true?()
第2题:
Which statement correctly describes network security settings in Cisco Network Assistant for the Catalyst Express 500 Switch?()
第3题:
The network administrator has discovered that the power supply has failed on a switch in the company LAN and that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 2950 series switch.What must be done to ensure that this new switch becomes the root bridge on the network?()
第4题:
The network administrator has discovered that the power supply has failed on a switch in the company LAN and that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 2950 series switch. What must be done to ensure that this new switch becomes the root bridge on the network?()
第5题:
You need to design the VLAN scheme for the Company network. Which two statements are true about best practices in VLAN design?()
第6题:
The IP subsystem fallover behavior of a two-node cluster is being testing in a large client organization. One of the tests is to simulate a network_down event and verify that HACMP movesthe single resource group to the standby node. What is the best way to simulate a network down condition?()
第7题:
One router is running RIPv1.
RIP neighbor is 224.0.0.9.
The network contains a loop.
Network 10.10.1.0 is reachable.
第8题:
one
three
two
zero
第9题:
It maximizes network throughput, while minimizing network latency.
It maximizes network throughput, as well as network latency.
It avoids the virtual switch stack and allows the virtual machine direct access to the actual network switch.
It prevents the virtual machine from accessing the network switch directly.
第10题:
Lower the bridge priority number.
Change the MAC address of the switch.
Increase the VTP revision number for the domain.
Lower the root path cost on the switch ports.
Assign the switch an IP address with the lowest value.
第11题:
MAC filtering
IP address
PoE
Port speed
第12题:
Enable VTP pruning on any switch in the management domain
Enable VTP pruning on any client switch in the domain
Enable VTP pruning on a VTP server in the management domain
Enable VTP pruning on every switch in the domain
None of the other alternatives apply
第13题:
The Company network administrator has entered the "auto qos voip cisco-phone" command on switch R1. What does this command do?()
第14题:
A VTP domain has six active VLANs. Without notice, all VLANs except VLAN1 fail. Just prior tothe failure, Switch2 was added to the network. Which three issues on Switch2 could be the cause?()
第15题:
A network administrator needs to force a high-performance switch that is located in the MDF to become the root bridge for a redundant path switched network. What can be done to ensure that this switch assumes the role as root bridge()。
第16题:
The Company network administrator needs to enable VTP pruning within the Company network. What action should a network administrator take to enable VTP pruning on an entire management domain?()
第17题:
A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?()
第18题:
Single switch
第19题:
Free up more ports on the switch
Enable server load balancing
Move the second network adapter to a new subnet
Enable network adapter teaming
第20题:
第21题:
Blade servers
Rackmount servers
Tower servers
Web servers
第22题:
one
three
two
zero
第23题:
Routing should occur at the access layer ifvoice VLANs are utilized. Otherwise, routing should occur at the distribution layer.
Routing should always be performed at the distribution layer.
VLANs should be localized to a switch.
VLANs should be localized to a single switch unlessvoice VLANs are being utilized.
Routing should not be performed between VLANs located on separate switches.