A. a primary route,stored in the routing table
B. a backup route,stored in the routing table
C. a backup route,stored in the topology table
D. a primary route,stored in the topology table
第1题:
Which two statements about the EIGRP DUAL process are correct?()
第2题:
Which of the following is true regarding the effect of EIGRP queries on the network design?()
第3题:
Which statements are true about EIGRP successor routes?()
第4题:
Which statements are true about EIGRP successor routes? ()
第5题:
A router has EIGRP configured as the only routing protocol. How does EIGRP respond if there is no feasible successor route to a destination network and the successor route fails?()
第6题:
Which statements are true about EIGRP successor routes (Choose two.)()。
第7题:
a primary route,stored in the routing table
a backup route,stored in the routing table
a backup route,stored in the topology table
a primary route,stored in the topology table
第8题:
An error will result because a router cannot be configured with an EIGRP variance of 3 becausethe maximum variance number is 2
The successor route will end up in the routing table, and so will any route with a metric at mostthree times greater than the value of the successor’s metric
EIGRP will only advertise routes that are within three hops of the current router
The successor route will end up in the routing table, and so will any route with a metric at leastone third the value of the successor’s metric
The best three routes with equal cost paths will end up in the routing table
The successor route will be any route with three times the value of the advertised distance
第9题:
The neighbor's advertised distance must be less than or equal to the feasible distance of the current successor.
The neighbor's advertised distance must be less than the f easible distance of the current successor.
The neighbor's advertised distance must be greater than the feasible distance of the current successor.
The neighbor's advertised distance must be equal to the feasible distance of the current successor .
The neighbor's advertised distance must be greater than or equal to the feasible distance of the current successor.
第10题:
Passive routes are in the process of being calculated by DUAL.
EIGRP supports VLSM, route summarization, and routing update authentication.
EIGRP exchanges full routing table information with neighboring routers with every update.
If the feasible successor has a higher advertised distance than the successor route, it becomes the primary route.
A query process is used to discover a replacement for a failed route if a feasible successor is not identified from the current routing information.
第11题:
A successor route is used by EIGRP to forward traffic to destination.
Successor routes are saved in the topology table to be used if the primary route fails.
Successor routes are flagged as active in the routing table.
A successor route may be backed up by a feasible successor route.
Successor routes are stored in the neighbor table following the discovery process.
第12题:
EIGRP queries will be the most significant issue with respect to stability and convergence
EIGRP queries are not a consideration as long as EIGRP has a feasible successor with a nexthop AD that is greater than the FD of the current successor route
EIGRP queries will only increase the convergence time when there are no EIGRP stubsdesigned in the network
第13题:
After DUAL calculations, a router has identified a successor route, but no routes have qualified as a feasible successor. In the event that the current successor goes down, what process will EIGRP use in the selection of a new successor?()
第14题:
Which condition must be satisfied before an EIGRP neighbor can be considered a feasiblesuccessor?()
第15题:
Which command will display all the EIGRP feasible successor routes known to a router?()
第16题:
A router has been configured with an EIGRP variance of 3. Which of the following statements istrue?()
第17题:
Which two statements are true regarding EIGRP?()
第18题:
An EIGRP route will go active if there are no successors or feasible successors in the EIGRP topology table.
An EIGRP route will go passive if there are no successors in the EIGRP topology table.
DUAL will trigger an EIGRP query process while placing the flapping routes in the holddown state.
A feasible successor in the EIGRP topology table can become the successor only after all the query requests have been replied to.
The stuck in active state is caused when the wait for the query replies have timed out.
EIGRP queries are sent during the loading state in the EIGRP neighbor establishment process.
第19题:
A successor route is used by EIGRP to forward traffic to a destination.
Successor routes are saved in the topology table to be used if the primary route fails.
Successor routes are flagged as active in the routing table.
A successor route may be backed up by a feasible successor route.
Successor routes are stored in the neighbor table following the discovery process.
Successors are not used in EIGRP.
第20题:
It immediately sends its entire routing table to its neighbors.
EIGRP sends a Hello packet to the DR to inform it of the route failure.
It automatically forwards traffic to a fallback default route until a successor route is found.
It sends queries out to neighbors until a new successor route is found.
It places the route in holddown until LSA updates inform it of a new route to the network.
第21题:
Router# show ip eigrp routes *
Router# show ip eigrp summary
Router# show ip eigrp topology
Router# show ip eigrp adjacencies
Router# show ip eigrp neighbors detail
第22题:
EIGRP will automatically use the route with the lowest advertised distance (AD) .
The route will transition to the active state.
The route will transition to the passive state.
EIGRP will find the interface with the lowest MAC address.
EIGRP will automatically use the route with the lowest feasible distance (FD).
第23题:
A successor route is used by EIGRP to forward traffic to a destination.
Successor routes are saved in the topology table to be used if the primary route fails.
Successor routes are flagged as active in the routing table.
A successor route may be backed up by a feasible successor route.
Successor routes are stored in the neighbor table following the discovery process.
第24题:
a primary route,stored in the routing table
a backup route,stored in the routingt able
a backup route,stored in the topology table
A primary route,stored in the topology table