Which configuration command creates a virtual router called isp－1?()A.virtual-routerisp-1B.virtual-routerISP-1C.virtual-routerVRisp-1D.virtual-routerVRISP-1

题目
Which configuration command creates a virtual router called isp－1?()

A.virtual-routerisp-1

B.virtual-routerISP-1

C.virtual-routerVRisp-1

D.virtual-routerVRISP-1

相似考题

1.以下OMC菜单功能，哪些可以用于邻区配置?______A、Configuration->WirelessConfigApplication->NERelationManagementB、Configuration->WirelessConfigApplication->InterMeConfigurationImportandExportC、Configuration->WirelessConfigApplication->CellToolD、Configuration->NEManagement

2.假设在LAC路由器上运行show vpdn命令，路由器软件系统输出的配置信息如图5-17所示。结合图 5-15所示的网络拓扑结构，请将(5)～(9)空缺处填写完整，完成在LAC上对L2TPv2协议的相关配置。Router_LAC(config)vpdn enableRouter_LAC(config) (5) (创建相应vpdn组，并进入该组的配置模式)(6) (接受对端发起L2TP通道连接请求，并根据virtual—template 1创建virtual-access接口)Router_LAC(config-vpdnl) (7) (启用L2TP通道验证功能)Router_LAC(config-vpdnl)12tp tunnel password! abcd1234!(8)Router_LAC(config) (9) (创建并进入相应的L2TP虚接口模板)(其他配置略)

3.You wish to configure IPv6 support on a router which does not have any current IPv4 configuration.Which three steps are used to configure IPv6 with an accompanying IGP in JUNOS software? ()A. set protocols isis inet6B. set routing-options router-id router-idC. set protocols ospf3 area 0 interface allD. set interface fe-0/0/1 unit 0 family inet6E. set routing-options ipv6-router-id router-id

4.假设在LAC路由器上运行show vpdn命令，路由器软件系统输出的配置信息如图8-18所示。结合图 8-16所示的网络拓扑结构，请将(5)～(9)空缺处填写完整，完成在LAC上对L2TPv2协议的相关配置。Router_LAC(config) vpdn enableRouter_LAC(config) (5) (创建相应vPdn组，并进入该组的配置模式)(6) (接受对端发起L2TP通道连接请求，并根据virtual-template 1创建virtual-access接口)Router_LAC(config-vpdn1) (7) (启用L2TP通道验证功能)Router_LAC(config-vpdn1) 12tp tunnel password !abcd1234!(8)Router_LAC (config) (9) (创建并进入相应的L2TP虚接口模板)(其他配置略)

参考答案和解析
参考答案：A
更多“Which configuration command creates a virtual router called isp－1?() ”相关问题

  • 第1题：

    Which three statements are correct regarding the CLI command, 12tp destination profile to－NewYork virtual－router vr1 ip address 1.1.1.1 ? ()(Choose three.)

    A. LNS IP address is defined.

    B. LAC IP address is defined.

    C. Virtual-router vr1 sends and receives L2TP traffic.

    D. Virtual-router vr1 is the authenticating virtual-router.

    E. This command is performed on the LNS.


    参考答案：B, C, E

  • 第2题：

    Which command will delete the current rescue configuration?()

    A. user@router# system delete configuration rescue

    B. user@router> request system configuration rescue delete

    C. user@router# delete rescue configuration

    D. user@router> file delete rescue-configuration


    参考答案：B

  • 第3题：

    Refer to the exhibit. During the process of configuring a virtual link to connect area 2 with the backbone area, the network administrator received this console message on R3:*Mar 1 00:2 5:01.084: %OSPF -4- ERRRCV: Received invalid packet: mismatch area ID, from backbone area must be virtual link but not found from 20.20.20.1, Serial 0 .How should the virtual link be configured on the OSPF routers to establish full connectivity between the areas?（）

    A.R1(config - router)# area 0 virtual - link 1.1.1.1R3(config - router)# area 2 virtual - link 3.3.3.3

    B.R1(config - router)# area 1 virtual - link 2.2.2.2 R3(config - router)# area 1 virtual - link 2.2.2.2

    C.R1(config - router)# area 1 virtual - link 20.20 .20.2 R3(config - router)# area 1 virtual - link 30.30.30.2

    D.R1(config - router)# area 1 virtual - link 30.30.30.3 R3(config - router)# area 1 virtual - link 20.20.20.1

    E.R1(config - router)# area 1 virtual - link 3.3.3.3 R3(config - router)# area 1 virtual - link 1.1 .1.1


    参考答案：E

  • 第4题：

    The output of the show aaa domain-map displays the following information:Domain: isp1.com; virtual-router: vr1; loopback: 1Domain: isp2.com; virtual-router: vr2; loopback: 1Domain: none; virtual-router: vr3; loopback: 1Domain: default; virtual-router: vr4; loopback: 1The end user supplies a login name of joe@isp7.com .Which virtual router is responsible for authenticating this user?（）

    A. vr1

    B. vr2

    C. vr3

    D. vr4


    参考答案：D

  • 第5题：

    邻区配置工具的入口菜单为_________.

    A、Configuration ->Wireless Config Application ->NE Relation Management

    B、Configuration ->Wireless Config Application ->Inter Me Configuration Import and Export

    C、Configuration ->Wireless Config Application ->Cell Tool

    D、Configuration ->NE Management


    标准答案：A

  • 第6题：

    ThefollowingcommandisissuedonaCiscoRouter:Router(configuration)loggingconsolewarningsWhichalertswillbeseenontheconsole?()

    A.Warningsonly

    B.debugging，informational，notifications，warnings

    C.warnings，errors，critical，alerts，emergencies

    D.notifications，warnings，errors

    E.warnings，errors，critical，alerts


    参考答案：C

相关内容