Which two statements are true about using IPv4 and IPv6 simultaneously on a network segment? ()
第1题:
A. IPv6 allows a host to create its own IPv6 address that will allow it to communicate to other devices on a network configured via DHCP. IPv4 does not provide a similar capability for hosts.
B. IPv6 provides for more host IP addresses but IPv4 provides for more network addresses.
C. Hosts can be configured to receive both IPv4 and IPv6 addresses via DHCP.
D. Host configuration options for IPv4 can be either statically assigned or assigned via DHCP.Host configuration options for IPv6 can be statically assigned only.
E. IPv4 and IPv6 addresses c an be simultaneously assigned to a host but not to a router interface.
第2题:
A. telnet access does not require a password
B. nat
C. no broadcast
D. chanage of destination address in the ipv6 header
E. chanage of source address in the ipv6 header
F. autoconfiguration
第3题:
A company is using 6to4 tunneling within their IPv6 network. Which two statements about this kindof tunneling are accurate?()
第4题:
A Company is using 6to4 tunnels in their IPv6 network. Which two statements are true about thesetunnels?()
第5题:
the network administrator has been asked to give reasons for moving from ipv4 to ipv6. what are two valid reasons for adopting ipv6 over ipv4?()
第6题:
Which functionality is required within an IP router that is situated at the boundary of an IPv4 network and an IPv6 network to allow communication between IPv6- only and IPv4 - only nodes?()
第7题:
Company network is implemting IPv6 into their existing IPv4 netwrok. Which statement is trueabout incorporating IPv6 into an already existing IPv4 network?()
第8题:
Tunnel IPv6 over IPv4 to connect far-end IPv6 networks
Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible
Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible
What is the meaning of EUI-64 and how does it work?
Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.
第9题:
Autoconfiguration
Automatic 6to4 Tunnel
Automatic 6to4 Relay
Network Address Translator - Protocol Translator (NAT - PT)
Intrasite Automatic T unnel Address Protocol (ISATAP)
第10题:
IPv6 allows a host to create its own IPv6 address that will allow it to communicate to other devices on a network configured via DHCP. IPv4 does not provide a similar capability for hosts.
IPv6 provides for more host IP addresses but IPv4 provides for more network addresses.
Hosts can be configured to receive both IPv4 and IPv6 addresses via DHCP.
Host configuration options for IPv4 can be either statically assigned or assigned via DHCP.Host configuration options for IPv6 can be statically assigned only.
IPv4 and IPv6 addresses c an be simultaneously assigned to a host but not to a router interface.
第11题:
a pseudora ndom generated number
its locally configured IPv4 address
the DHCP - supplied device ID
its MAC address
第12题:
IPv4 packets are carried over IPv6 tunnels to the LSN while IPv6 traffic is forwarded natively.
Ipv6 packets are carried over IPv4 tunnels to the LSN while IPv4 traffic is forwards natively.
The LSN performs NAT44 on private IPv4 source addresses.
DS-Lite does not perform any address translation.
第13题:
A. The edge routers can use any locally configured IPv6 address.
B. Hosts and routers inside a 6to4 site will need a special code.
C. An edge router must use IPv6 address of 2002::/16 in its prefix.
D. IPv4 traffic is encapsulated with an IPv6 header.
第14题:
During the IPv6 autoconfiguration, what does the device append to the 64- bit prefix that it receives from the router to create its IPv6 address?()
第15题:
Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4 tunnel?()
第16题:
Which of the following solutions will encapsulate IPv6 packets with IPv4 headers?()
第17题:
Your company is researching a new application that runs over IPv6, but part of it must still have IPv4 support. Your company uses a traditional IPv4 network. Your plan is not to run IPv6 over the whole network, but to segment parts of the network or even to operate simultaneously with IPv6 and IPv4. You must make a brief presentation about IPv6 technology to the board of technical directors. Which three of these items could be part of your presentation? ()
第18题:
You need to decide on the best router redundancy protocol to use in the Company network. Which two statements are true about HSRP, VRRP, and GLBP?()
第19题:
Which two statements about DS-Lite are true?()
第20题:
Only OSPF version 3 can be utilized for routing IPv4 and IPv6
IPv4 and IPv6 networks can be routed simultaneously
IPv6 can be routed using the same routing protocol versions as IPv4
A router routing for IPv6 and IPv4 must convert IPv4 packets to IPv6 packets to route them
None of the other alternatives apply
第21题:
Create an IPv4 tunnel and assign the tunnel IPv6 addresses
Create IPv4 interfaces on both ends of the network, and use either static routes or a routingprocess to direct IPv6 packets through those interfaces
IPv6 packets cannot be encapsulated with IPv4 headers because the addresses are notcompatible
Create IFV6 interfaces on both ends of the network, and use static routes to point the IPv4address to those interfaces
Use an IPv6 routing protocol like OSPFv3 and assign IPv4 packets to that process
Create an IPv4 tunnel and use the tunnel mode ipv6ip command
第22题:
telnet access does not require a password
nat
no broadcast
chanage of destination address in the ipv6 header
chanage of source address in the ipv6 header
autoconfiguration
第23题:
In a 6to4 tunnel, the first two bytes of the IPv6 address will be 0x2002 and the next four byteswill be the hexadecimal equivalent of the IPv4 address
In a 6to4 tunnel, the IPv4 address 192.168.99.1 would be converted to the2002:1315:4463:1::/64 IPv6 address
In a 6to4 tunnel, the IPv4 address 192.168.99.1 would be converted to the 2002:c0a8:6301::/48IPv6 address
In a 6to4 tunnel, the first two bytes of the IPv6 address will be locally derived and the next twobytes will be the hexadecimal equivalent of the IPv4 address
In a 6to4 tunnel, the IPv4 address 192.168.99.1 would be converted to the 2002:c0a8:6301::/16IPv6 address