Which two field-replaceable units FRUs are hot-swappable?()
第1题:
A.Router John uses alink-state routing protocol.
B.Router John will receive routing updates on the Serial0/0 interface.
C.Router John will receive routing updates on the Serial0/1 interface.
D.Router John will send routing updates out the Serial0/0 interface.
E.Router John will send routing updates out the FastEthernet0/0 interface.
F.Router John will send routing updates out the Serial0/1 interface.
第2题:
A.a switch with a trunk link that is configured between the switches
B.a router with an IP address on the physical interface that is connected to the switch
C.a switch with an access link that is configured between the switches
D.a router with subinterfaces configured on the physical interface that is connected to the switch
第3题:
Which statement is true regarding the Port Aggregation Protocol? ()
第4题:
When configuring Frame Relay using point-to-point subinterfaces, which of the following must not be configured?()
第5题:
Which two of these steps are minimum requirements to configure OSPFv3 under IPv6?()
第6题:
Which three elements must be used when you configure a router interface for vlan trunking?()
第7题:
It has become necessary to configure an existing serial interface to accept a second Frame Relay virtualcircuit.Which of the following processes are required to accomplish this task?()
第8题:
Which statements are valid for a local SPAN configuration? ()
第9题:
Which two statements are correct regarding units in JUNOS?()
第10题:
If the interface is disabled, the logical unit will administratively shutdown.
If the interface is deactivated, the physical interface will administratively shutdown.
If the interface is deactivated, the interface configuration is ignored during commit.
If the interface is disabled, the logical unit configuration is ignored during commit.
第11题:
Routing Engine on M10i
Physical Interface Card on M7i
fan tray on J-series routers
Physical Interface Modules on J6300 router
第12题:
one IP network or subnetwork for each subinterface
subinterface numbering that matches vlan tages
subinterface encapsulation identifiers that match vlan tags
a management domain for each subinterface
one physical interface for each subinterface
one subinterface per vlan
第13题:
On corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs. What is needed to allow communication between the VLANs?()
A.a router with subinterfaces configured on the physical interface that is connected to the switch
B.a router with an IP address on the physical interface connected to the switch
C.a switch with an access link that is configured between the switches
D.a switch with a trunk link that is configured between the switches
第14题:
A. Router John uses a link-state routing protocol.
B. Router John will receive routing updates on the Serial0/0 interface.
C. Router John will receive routing updates on the Serial0/1 interface.
D. Router John will send routing updates out the Serial0/0 interface.
E. Router John will send routing updates out the FastEthernet0/0 interface.
F. Router John will send routing updates out the Serial0/1 interface.
第15题:
Hosts on the same VLAN can communicate with each other but are unable to communicate with hosts on different VLANs. What is needed to allow communication between VLANs()。
第16题:
Which two statements are true regarding interface properties? ()
第17题:
Overlay Transport Virtualization (OTV) join interface is used to source the OTV encapsulated traffic and send it to the Layer 3 domain of the data center network. Which statements are true about OTV join interface? ()
第18题:
Which two statements are true about the role of split horizon?()
第19题:
Which three causes could prevent a host from getting an IPv6 address with stateless autoconfiguration?()
第20题:
On corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs. What is needed to allow communication between the VLANs?()
第21题:
Which two statements are true about hierarchical architecture? ()(Choose two.)
第22题:
Source and destination interface must be on the same host
Source and destination interfaces can be on different hosts
Destination vEthernet interface can be on a different VLAN than the source
Destination interface can be a physical port
Destination interface cannot be a physical port
第23题:
Join interface is a Layer 3 entity, and with the Cisco NX-OS release 6.0, it can only be defined as a physical interface, physical subinterface, Layer 3 port channel, or Layer 3 port channel subinterface.
A single join interface can be defined and associated with a given OTV overlay.
Multiple overlays can also share the same join interface.
Join interface can be a loopback interface.
The join interface is a Layer 3 entity that can be defined as a physical interface but not as a logical one.