made during the filming of the picture
edited by an optical sensor
inserted on the film
marked on the gramophone
第1题:
A.A
B.B
C.C
D.D
第2题:
The system administrator did a new install of AIX on a server about a week ago. The system was not rebooted after the installation. CDE is running on this system as is TCPIP. The system administrator has started configuring the system percompany directives. The power cable was inadvertently disconnected from the wall causing the sever to lose power. Upon reboot, the system appears to hang during log in from the console or from Xterminals. Which of the following is the most probable cause?()
A.It is a hardware problem caused by the power failure.
B.There is a network problem, most probably with name resolution.
C.Sine the system was never rebooted, devices are marked defined instead of available and need to be activated.
D.Some filesets may be marked as broken and need to be reinstalled.
第3题:
A system administrator has edited the necessary files for setup of an AIX system to serve as a bootp server. Which of the following commands is required to complete the activation?()
第4题:
An administrator has made several topology and resource group changes on one node in a running cluster.During verification and synchronization, using the "Emulate" option, many errors are reported. Theadministrator decided the best course of action was to roll back the changes. Prior to the changes beingmade, a cluster snapshot was taken. Which of the following actions will roll back the changes with the least disruption?()
第5题:
Perform a synchronization from a node without the changes.
Apply the cluster snapshot on both nodes while the cluster is running.
Restore HACMP Configuration Database from Active Configuration on the node where the changes weremade
Stop the cluster using the option Unmanage Resource Groups and apply the cluster snapshot on thenode where the changes were made
第6题:
Init
2Way
ExStart
Exchange
第7题:
ago
before
ahead
front
第8题:
warm-up allows the hydraulic system to become charged with oil
warm-up allows the relief valves to be properly tested
hydraulic strainers operate only during the warm-up period
hydraulic fluid must be at the proper viscosity
第9题:
NAVTEX, COSPAS/SARSAT, EPIRBs and Status Recording-system
Inmarsat,COSPAS/SARSAT, EPIRBs and Status Recording-system
NAVTEX, Inmarast,EPIRBs and SART
Inmarsat, direct Printing Telegraphy
第10题:
got out of synchronization with pictures
were too large for most movie theaters
were newly invented
changed speeds when the needle jumped
第11题:
Because row IDs may change during the flashback operation
Because the object number changes after the flashback operation
Because the rows are retrieved from the recycle bin during the flashback operation
Because the table is moved forward and back to a temporary during the flashback opertion
第12题:
is made to circulate out of the system
is made to circulate within the system
is made circulate within the system
is made circulate out of the system
第13题:
A. SONET and SDH both use time-division multiplexing.
B. An optical transport network system uses time-division multiplexing.
C. SONET and SDH both use wavelength-division multiplexing.
D. An optical transport network system uses wavelength-division multiplexing.
第14题:
Refer to the exhibit. Autonomous systems 200 and 300 have EBGP sessions established with their directly connected routers in au tonomous system 100. IGP has been configured on all routers in autonomous system 100 and they successfully exchange routing updates. Traffic originated in autonomous system 200 cannot reach the destination autonomous system 300. What configuration shoul d be done on the routers in autonomous system 100 in order for the traffic coming from autonomous system 200 to be forwarded to autonomous system 300?()
A. IBGP session must be established between routers R1 R2 and R2 R3, and the synchronization must be turned off.
B. IBGP speakers within autonomous 100 must be fully meshed, and the synchronization must be turned on.
C. IBGP session must be established between routers R1 R2 and R2 R3, and the synchronization must be turned on.
D. IBGP session mu st be established between routers R1 and R3, and the synchronization must be turned off.
E. IBGP speakers within autonomous 100 must be fully meshed, and the synchronization must be turned off.
F. IBGP session must be established between routers R1 and R3, and the synchronization must be turned on.
第15题:
During OSPF adjacency formation, in what state is a router when it is negotiating to be in charge of the database synchronization process?()
第16题:
Before a Flashback Table operation, you execute the following command: ALTER TABLE employees ENABLE ROW MOVEMENT; Why would you need this to be executed?()
第17题:
It is a hardware problem caused by the power failure.
There is a network problem, most probably with name resolution.
Sine the system was never rebooted, devices are marked defined instead of available and need to be activated.
Some filesets may be marked as broken and need to be reinstalled.
第18题:
telinit -q
startsrc -s bootpd
refresh -s inetd
第19题:
第20题:
mount -no /data
chfs -A no /data
mount -t nfs /data
chfs -a type=nfs /data
第21题:
SONET and SDH both use time-division multiplexing.
An optical transport network system uses time-division multiplexing.
SONET and SDH both use wavelength-division multiplexing.
An optical transport network system uses wavelength-division multiplexing.
第22题:
/etc/security/user
/etc/services
/etc/inetd.conf
/etc/hosts.equiv
第23题:
pump from the damaged tank
fight a fire
abandon ship
use the crossover system