upstream node
originating node
destination node
downstream node
第1题:
A.GPRS Service Network
B.GPRS Service Node
C.GPRS support Node
D.GPRS support Network
第2题:
How is SNCP and MS-SPRing traffic rerouted during a protection switch when a complete fiber cable cut occurs?()
第3题:
You have a router running BGP for the MPLS network and OSPF for the local LAN network at the sales office. A route is being learned from the MPLS network that also exists on the OSPF local network. It is important that the router chooses the local LAN route being learned from the downstream switch running OSPF rather than the upstream BGP neighbor. Also, if the local OSPF route goes away, the BGP route needs to be used. What should be configured to make sure that the router will choose the LAN network as the preferred path?()
第4题:
Which layer in the TCP/IP model is responsible for delivering packets to their destination?()
第5题:
Which statement correctly describes the disabling of IP TTL propagation in an MPLS network?()
第6题:
During the IPv6 address resolution, a node sends a neighbor solicitation message in order to discover which of these?()
第7题:
当设置了WINS服务器后,运行Windows 2003的计算机利用哪种模式解决NetBIOS名的解析?()
第8题:
to map all the devices on a network.
to display the current TCP/IP configuration values.
to see how a device MAC address is mapped to its IP address.
to see the path a packet will take when traveling to a specified destination.
to display the MTU values for each router in a specified network path from source to a destination.
第9题:
The Layer 2 multicast address of the destination node
The solicited node multicast address of the destination node
The Layer 2 address of the destination node based on the destination IPv6 address
The IPv6 address of the destination node based on the destination Layer 2 address
第10题:
The vessel moving upstream against the current
The vessel moving downstream with a following current
The vessel located more towards the channel centerline
The vessel with the least amount of maneuverability
第11题:
One adapter per node
Two adapters per node
Four adapters per node
No additional adapters per node
第12题:
SNCP traffic is switched from the first node that recieves the AIS. MS-SPRing traffic is rerouted from the first in the ring.
SNCP traffic is selected at the destination node in the ring. MS-SPRing is rerouted from the originating node in the ring.
SNCP traffic is rerouted from the originating node in the ring. MS-SPRing traffic is rerouted from the originating node in the ring.
SNCP traffic is selected at the destination node in the ring. MS-SPRing traffic is rerouted from the last reachable node in the ring.
第13题:
Overlay Transport Virtualization (OTV) uses the Authoritative Edge Device (AED) to perform which tasks?()
第14题:
If an edge Label Switch Router (LSR) is properly configured,which three combinations are possible?()
第15题:
Node ’A’ and ’B’ have two network adapters connected to different networks. Adapter 1 is assigned the address 192.168.0.10 with a subnet mask of 255.255.255.0. Adapter 2 is assigned the address 24.76.1.200 with a subnet mask of 255.255.240.0. What is the minimum number of additional adapters per node required to eliminate a network adapter as a single point of failure?()
第16题:
GSN是什么的缩写?()
第17题:
Which two of these are characteristics of MPLS VPNs?()
第18题:
Which device is responsible for assigning label values in an MPLS network?()
第19题:
The Layer 2 multicast address of the destination node
The solicited node multicast address of the destination node
The Layer 2 address of the destination node based on the destination IPv6 address
The IPv6 address of the destination node based on the destination Layer 2 address
第20题:
The TTL field from the IP packet is copied into the TTL field of the MPLS label header at the ingress edge LSR
TTL propagation cannot be disabled in an MPLS domain
TTL propagation is only disabled on the ingress edge LSR
The TTL field of the MPLS label header is set to 255
The TTL field of the IP packet is set to 0
第21题:
The AED is responsible for sending all unicast traffic in a site, while either node in a site can transmit multicast and broadcast.
The AED is responsible for load balancing all traffic for all VLANs across the transport network.
The AED is responsible for handling all unicast, broadcast, and multicast traffic for a given VLAN within a site.
The AED is responsible for MAC address dispute contention for a given VLAN.
第22题:
创建节点:create/node
列出节点:cat/node
获取节点数据:get/node
删除节点:delete/node
第23题:
static route needs to be added
floating static route needs to be added
bgp backdoor command
ospf backdoor command