chroot
route static
route add
smitty route
第1题:
Which three are used in configuring Call Manager dial plans? ()
第2题:
Which of the following commands should be used to make permanent static route entries that will persist across reboots?()
第3题:
Which of the following commands will enable you to see the contents of the IP routing table andsend the output to a TFTP server at the same time?()
第4题:
Which of the following should be flashed on a firewall to make sure it is the most current version available?()
第5题:
A customer who has a two node PowerHA cluster, with each node being at a different site and using cross siteLVM, plans to add a third heartbeat to further reduce the chance of data divergence or partitioned cluster. Theheartbeat will make use of spare adapters in the nodes. However, the heartbeats must go via an externalnetwork requiring static routes to be added for cluster functionality.How can this be achieved?()
第6题:
What is the role of route preference?()
第7题:
The command is used to establish a static route.
The default administrative distance is used.
The command is used to configure the default route.
The subnet mask for the source address is 255.255.255.0
The command is used to establish a stub network
第8题:
Configure the static route in the /etc/rc.net file
Using application Start/Stop scripts to manage the static route
Configure Pre and Post event commands to manage the static route
Using smitty route command to create the static route and update the ODM
第9题:
The route is not advertised into BGP.A.The route is not advertised into BGP.
The route is advertised into BGP with metric 10.B.The route is advertised into BGP with metric 10.
The route is advertised into BGP with metric 20.C.The route is advertised into BGP with metric 20.
The route is advertised into BGP with default metric.D.The route is advertised into BGP with default metric.
第10题:
static route needs to be added
floating static route needs to be added
bgp backdoor command
ospf backdoor command
第11题:
route
netstat
iptrace
traceroute
第12题:
show ip route ∣ to tftp://192.168.1.1/route.txt
show ip route ∣ tee tftp://192.168.1.1/route.txt
show ip route ∣ include tftp://192.168.1.1/route.txt
show ip route ft include tJtp://19Z168.1.1/route.txt
show ip route ∣ redirect tftp://192.168.1.1/route.txt
第13题:
You have a router running BGP for the MPLS network and OSPF for the local LAN network at the sales office. A route is being learned from the MPLS network that also exists on the OSPF local network. It is important that the router chooses the local LAN route being learned from the downstream switch running OSPF rather than the upstream BGP neighbor. Also, if the local OSPF route goes away, the BGP route needs to be used. What should be configured to make sure that the router will choose the LAN network as the preferred path?()
第14题:
在MSR路由器上使用()命令配置静态路由。
第15题:
The following configuration command was entered into a router:ip route 172.16.3.0 255.255.255.0 192.168.2.4 Which of the following statements are true regarding this configuration change?()
第16题:
Which of the following commands is used to determine the route that the IP packets take to a network host?()
第17题:
Which of the following commands should be used to display a system routing table?()
第18题:
It is used to determine which route should become active.
It is used to select which routing table to use for forwarding.
It is used to determine what routes to accept into the routing table.
It is used to select the best route between multiple equal cost paths.
第19题:
set routing-options static route 10.1.1.1/32 no-retain
set routing-options static route 10.1.1.1/32 discard
set routing-options static route 10.1.1.1/32 reject
set routing-options static route 10.1.1.1/32 passive
第20题:
It is a route to be used when the routing protocol fails.
It is a route configured by an ISP that sends traffic into a corporate network.
It is a route used when a packet is destined for a remote network that is not listed in the routing table.
It is a route manually configured for a specific remote network for which a routing protocol is not configured.
It is used to send traffic to a stub network.
第21题:
ip route 172.16.1.0 255.255.255.0 0.0.0.0
ip route 172.16.1.0 255.255.255.0 172.16.2.1
ip route 0.0.0.0 255.255.255.0 172.16.2.1
ip route 0.0.0.0 0.0.0.0 172.16.2.1
第22题:
A static route that points towards the Cisco Easy VPN server is created on the remote client.
A static route is created on the Cisco Easy VPN server for the internal IP address of each VPN client.
A default route is injected into the route table of the remote client.
A default route is injected into the route table of the Cisco Easy VPN server.
第23题:
route
netstat
iptrace
traceroute