224.0.0.39
224.0.1.39
224.0.0.40
224.0.1.40
第1题:
Which two of the following Cisco router platforms support Multicast Distributed Fast Switching?()
第2题:
What does the command ip pim send-rp-discovery scope 16 achieve?()
第3题:
In PIM-SM operations, the first router connected to the multicast source sends the Register message towhich device?()
第4题:
In relation to MPLS Multicast VPN, which three statements about multicast distribution (MDT) groups aretrue? ()
第5题:
Which of the following multicast mode does Auto-RP require?()
第6题:
In order to configure two routers as anycast RPs, which of these requirements, af a minimum, must besatisfied?()
第7题:
MPLS label mapping on an LSR is displayed by which IOS command?()
第8题:
Which multicast groups support Auto-RP mapping and discovery?()
第9题:
It is used for PIM control traffic
It is optionally configured for a high bandwidth multicast source to reduce multicast traffic replication to uninterested PE routers
Within the VPF configuration in the PE router, multiple Default MDT groups are configured so each VPF can support multiple multicast sources
There is a reduced multicast state in the MPLS core P routers
When multicast traffic exceeds a certain configured threshold, traffic from the Data MDT is switched to the Default MDT to conserve bandwidth
第10题:
224.0.0.39
224.0.1.39
224.0.0.40
224.0.1.40
第11题:
3600 series
7200 series with NSE-1
7500 series
12000 series
第12题:
Default MDT groups are used for PIM control traffic, low-bandwidth sources, and flooding of sparse mode traffic.
MDTs are built in customer networks
Data MDT groups are used for high-bandwidth sources to reduce replication to uninterested PEs.
MDTs are built in provider networks
The number of MDTs depends on PIM modes of MDT groups.
第13题:
In Multicast VPN (MVPN) implementations, which two of the following statements are regarding the DefaultMDT Group?()
第14题:
Which type of domains is interconnected using Multicast Source Discovery Protocol?()
第15题:
Which statement is correct in reference to IPv6 multicast?()
第16题:
The ip pim autorp listener command is used to do which of these?()
第17题:
Which multicast address is reserved for cisco-rp-discovery?()
第18题:
In order to configure two routers as anycast RPs,which of these requirements,at a minimum, must be satisfied?()
第19题:
Which multicast mode does Auto-RP require?()
第20题:
Which two multicast groups support Auto-RP mapping and discovery?()
第21题:
ip pim rp-address
ip pim ssm
ip pim sparse-mode
ip pim passive
第22题:
it enables PIM BSR
it makes the router an Auto-RP mapping agent
it advertises the router as an RP with Auto-RP
it makes the router an Auto-RP client
第23题:
PIM-SM
PIM-DM
PIM-SSM
DVMRP