A. The command establishes a static route
B. The command invokes a dynamic routing protocol for 192.168.12.0
C. Traffic for network 192.168.12.0 is forwarded to 172.16.12.1
D. Traffic for all networks is forwarded to 172.16.12.1
E. This route is automatically propagated throughout the entire network
F. Traffic for network 172.16.12.0 is forwarded to the 192.168.12.0 network
第1题:
The network administrator of the Oregon router adds the follwing command to the router configuration: ip route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command?()
第2题:
You are a senior network administrator at TestKing, and while performing thepassword recovery procedure on your 2500 series Cisco router, you type in thefollowing command:o/r 0x2142What is the purpose of this command?()
第3题:
What does the ip access-routes configuration command accomplish?()
第4题:
A network administrator is troubleshooing an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval and the queue counts for the adjacent routers also need to be checked. What command will display the required information?()
第5题:
The command "ip route 192.168.24.64 255.255.255.192 192.168.8.2 100" was configured on a router named TK1. No routing protocols or other static routes are configured on the Corporate router yet.Based on this information, which statement is true about this command?()
第6题:
The following configuration command was entered into a router:ip route 172.16.3.0 255.255.255.0 192.168.2.4 Which of the following statements are true regarding this configuration change?()
第7题:
Which two statements are true about the command ip route 172.16.3.0 255.255.255.0 192.168.2.4?()
第8题:
ping
trace
show ip route
show interface
show cdp neighbors
第9题:
The command establishes a static route.
The command invokes a dynamic routing protocol for 192.168.12.0.
Traffic for network 192.168.12.0 is forwarded to 172.16.12.1.
Traffic for all networks is forwarded to 172.16.12.1.
This route is automatically propagated throughout the entire network.
Trafficfor network 172.16.12.0 is forwarded to the 192.168.12.0 network.
第10题:
The default administrative distance is used.
The command is used to establish a static route.
The command is used to configure the router interfaces.
The command is used to establish a stub network.
The subnet mask for the source address is 255.255.255.0
第11题:
The command is used to establish a static route.
The default administrative distance is used.
The command is used to configure the default route.
The subnet mask for the source address is 255.255.255.0
The command is used to establish a stub network
第12题:
NetFlow
SNMP
Debug
SysLog
EEM
CEF
第13题:
The following configuration command was issued on router TK1:ip route 172.16.3.0 255.255.255.0 192.168.2.1.Which of the following statements are true regarding this command?()
第14题:
Which command will configure a default route on a router?()
第15题:
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()
第16题:
Which three statements are true about EIGRP route summarization?()
第17题:
A network administrator enters the command clear ip route * and as a result he sees the message,"Please update the network documentation to record why the ip routing table was cleared." Which router feature was used in this case?()
第18题:
Router R1 exists in an Enterprise that uses EIGRP as its routing protocol. The show ip route command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0". Whic h of the following is most likely to have caused this output to occur on R1?()
第19题:
While troubleshooting a network connectivity issue, you suspect that a router may be missing a route, or may be receiving bad routing information to a destination. What command should you issue to view the route that the router will use to reach a given destination?()
第20题:
Configure the net system - id command under routerisis and enable IS - IS on each interface with the ip router isis command.
Configure the net sy stem - id and the network net - id commands under routerisis.
Configure the network net - id command(s) under routerisis and enable IS - IS on each interface with the ip router isis command.
Configure the network net - id command(s) and the is - type level -1- 2 command under routerisis.
Configure the net system - id and the network net - id commands under routerisis and enable ISIS on each interface with the ip router isis command.
第21题:
Issue the show ip route command on Router A
Issue the show ip route command on Router B
Issue the show cdp neighbors command on Router B
Issue the show cdp neighbors detail command on Router C
Issue the show arp command on Router A
Issue the show arp command on Router B
第22题:
Update the configuration logs
Update the network wiring schematics
Update the network configuration procedures
Compare the configuration with the baseline
第23题:
The network administrator faled to save the configuration.
The configuration register is set to 0x2100.
The boot system flash command is missing from the configuration.
The configuraiton register is set to 0x2102.
The router is configured with the boot system startup command.