路由器S0/0 接口通过帧中继接入网络,在此路由器上看到如下接口信息: [MSR] display interface Serial 0/0 Serial0/0 current state: UP Line protocol current state: UP Internet Address is 3.3.3.1/24 Primary Link layer protocol is FR IETF LMI DLCI is 0, LMI type is Q.933a, frame relay DTELMI status enquiry sent 91, LMI status received 69 LMI status timeout 22, LMI message discarded 1 那么可知()
第1题:
A.The Serial0/0 interface is passing traffic.
B.The DLCI 100 was dynamically allocated by the router
C.The Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP server
D.The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloud
E.The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP
第2题:
While logged into a router you manually shut down the serial 0 interface using the "shutdown" interface configuration command. You then issue the "show interface serial 0" command in exec mode. What could you expect the status of the serial 0 interface to be?()
第3题:
两台空配置的MSR路由器MSR-1、MSR-2通过各自的S1/0接口背靠背互连,各自的GE0/0接口分别连接客户端主机HostA和HostB: HostA----GE0/0--MSR-1--S1/0---------S1/0--MSR-2--GE0/0----HostB 192.168.1.1 3.3.3.1 3.3.3.2 10.10.10.1 两台MSR 路由器的版本统一为Version 5.20, Release 1618P11,在两台路由器上做了如下的配置: MSR-1 上的配置: [MSR-1]interface GigabitEthernet 0/0 [MSR-1-GigabitEthernet0/0] ip address 192.168.1.1 255.255.255.0 [MSR-1]interface Serial 1/0 [MSR-1-Serial1/0] link-protocol ppp [MSR-1-Serial1/0]ip address 3.3.3.1 255.255.255.252 [MSR-1]rip [MSR-1-rip-1]network 192.168.1.0 [MSR-1-rip-1]network 3.3.3.1 (没有[MSR-1-rip-1]version 2) MSR-2 上的配置: [MSR-2]interface GigabitEthernet 0/0 [MSR-2-GigabitEthernet0/0] ip address 10.10.10.1 255.255.255.0 [MSR-2]interface Serial 1/0 [MSR-2-Serial1/0] link-protocol ppp [MSR-2-Serial1/0]ip address 3.3.3.2 255.255.255.252 [MSR-2]rip [MSR-2-rip-1]network 10.10.10.0 [MSR-2-rip-1]network 3.3.3.2network使能RIP的网段地址 根据以上配置后,两台路由器之间的广域网接口可以互通,两台主机HostA、HostB 都可以ping 通各自的网关GE0/0 的地址,那么下列哪些说法是正确的?()
第4题:
客户的两台路由器通过V.35 电缆背靠背连接在一起,并在V.35 接口上运行了PPP 协议,在其中一台路由器上有如下接口信息: [MSR-Serial0/0] display interface Serial 0/0 Serial6/0 current state: UP Line protocol current state: DOWN 从如上信息可以推测()
第5题:
客户的网络如下所示:HostA----GE0/0--MSR-1--S1/0---------S1/0--MSR-2--GE0/0----HostB 在两台路由器上的广域网接口分别作了如下配置: MSR-1: firewall enable acl number 3000 rule 0 deny ip source 192.168.0.0 0.0.0.255 rule 5 permit ip interface Serial1/0 link-protocol ppp firewall packet-filter 3000 outbound ip address 6.6.6.2 255.255.255.0MSR-2: interface Serial1/0 link-protocol ppp ip address 6.6.6.1 255.255.255.0 假设HostA 的IP 地址为192.168.0.2/24,路由以及其他相关接口配置都正确,那么()
第6题:
两台空配置的MSR 路由器MSR-1、MSR-2 通过各自的S1/0 接口背靠背互连,各自的GE0/0 接口分别连接客户端主机HostA 和HostB:HostA----GE0/0--MSR-1--S1/0---------S1/0--MSR-2--GE0/0----HostB 两台MSR 路由器的版本统一为Version 5.20, Release 1618P11,在两台路由器上做了如下的配置: MSR-1 上的配置:[MSR-1] interface GigabitEthernet 0/0 [MSR-1-GigabitEthernet0/0] ip address 192.168.1.1 255.255.255.0 [MSR-1] interface Serial 1/0 [MSR-1-Serial1/0] link-protocol ppp [MSR-1-Serial1/0] ip address 3.3.3.1 255.255.255.252 [MSR-1] rip [MSR-1-rip-1] network 192.168.1.0 [MSR-1-rip-1] network 3.3.3.1 MSR-2 上的配置:[MSR-2] interface GigabitEthernet 0/0 [MSR-2-GigabitEthernet0/0] ip address 10.10.10.1 255.255.255.0 [MSR-2] interface Serial 1/0 [MSR-2-Serial1/0] link-protocol ppp [MSR-2-Serial1/0] ip address 3.3.3.2 255.255.255.252 [MSR-2] rip [MSR-2-rip-1] network 10.10.10.0 [MSR-2-rip-1] network 3.3.3.1根据以上配置后,两台路由器之间的广域网接口可以互通,两台主机HostA、HostB 都可以ping 通各自的网关GE0/0 的地址,那么下列哪些说法是正确的?()
第7题:
客户的两台路由器通过V.35 电缆背靠背连接在一起,其中一台路由器上有如下接口信息: [MSR-Serial0/0]display interface Serial 0/0 Serial0/0current state: UP Line protocol current state: UP Description: Serial6/0 Interface The Maximum Transmit Unit is 1500, Hold timer is 10(sec) Internet Address is 6.6.6.1/30 Primary Link layer protocol is PPP LCP opened, IPCP opened 从上述信息可以得知()
第8题:
某网络环境形如:HostA----GE0/0--MSR-1--S1/0-----FrameRelay----S1/0--MSR-2--GE0/0----HostB其中,两台路由器MSR-1、MSR-2分别通过S1/0接入帧中继网络。在MSR-1的S1/0接口上配置IP地址3.3.3.1/24和DLCI31,而在MSR-2的S1/0接口上配置IP地址3.3.3.2/24和DLCI82。物理连接完全正常,其他默认配置相同。那么如下哪些说法是错误的?()
第9题:
路由器S0/0接口通过帧中继接入网络,在此路由器上看到如下接口信息:[MSR]displayinterfaceSerial0/0Serial0/0currentstate:UPLineprotocolcurrentstate:UPInternetAddressis3.3.3.1/24PrimaryLinklayerprotocolisFRIETFLMIDLCIis0,LMItypeisQ.933a,framerelayDTELMIstatusenquirysent91,LMIstatusreceived69LMIstatustimeout22,LMImessagediscarded1那么可知()。
第10题:
Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?()
第11题:
为了查看路由器上串口S0/0/1是DTE接口还是DCE接口,应该使用下面哪个命令?()
第12题:
Serial 0 is up, line protocol is up
Serial 0 is up, line protocol is down
Serial 0 is down, line protocol is down
Serial 0 is down, line protocol is up
Serial 0 is administratively down, line protocol is down
Serial 0 is administratively down, line protocol is up
第13题:
A.Serial 0 is up,line protocol is down
B.Serial 0 is down,line protocol is down
C.Serial 0 is down,line protocol is up
D.Serial 0 is administratively down,line protocol is
第14题:
Router# show interfaces serial 0/1 命令的输出显示了如下内容: Serial0/1 is down, line protocol is down. 线路协议为 down(关闭)的原因最可能是什么()
第15题:
客户的MSR路由器通过S0/0接口连接运营商网络,通过G1/0接口连接内部网络。目前网络运行正常,客户可以通过路由器正常访问Internet和Intranet所有业务。现在在MSR 上添加了如下配置: firewall enable firewall default deny acl number 3002 rule 0 deny tcp interface Serial0/0 link-protocol ppp firewall packet-filter 3002 inbound firewall packet-filter 3002 outbound 那么如下哪些应用可能不受影响()。
第16题:
客户路由器S0/0接入帧中继网络,在路由器的接口上有如下显示信息: Serial1/1 current state: UP Line protocol current state: DOWN Internet Address is 3.3.3.2/24 接口的协议状态为DOWN,那么据此分析()
第17题:
两台MSR路由器通过Serial1/0背靠背直连,其中在一台MSR路由器上看到如下配置: interface Serial1/0 ip address 8.8.8.2 255.255.255.0 # interface GigabitEthernet0/0 port link-mode route ip address 100.1.1.2 255.255.255.0 #rip 1 version 2 network 0.0.0.0 # ip route-static 0.0.0.0 0.0.0.0 8.8.8.1 假设两台路由器都正确配置了RIP,且所有接口都UP,那么关于此配置如下哪些分析是正确的?()
第18题:
两台空配置的MSR 路由器RTA、RTB 通过各自的Serial1/0 接口背靠背互连。在两台路由器上做如下配置: RTA: [RouterA-Serial1/0] link-protocol fr ietf [RouterA-Serial1/0] ip address 10.1.1.1 30 [RouterA-Seria11/0] fr map ip 10.1.1.2 30 RTB: [RouterB-Serial1/0] link-protocol fr ietf [RouterB-Serial1/0] interface serial0/0.1 [RouterB-Serial1/0.1] ip address 10.1.1.2 30 [RouterB-Serial1/0.1] fr map ip 10.1.1.1 30 路由器之间的物理链路良好,那么下面说法正确的是()。
第19题:
客户路由器S0/0接入帧中继网络,在路由器的接口上有如下显示信息:Serial1/1currentstate:UPLineprotocolcurrentstate:DOWNInternetAddressis3.3.3.2/24接口的协议状态为DOWN,那么据此分析()。
第20题:
客户的网络如下所示:HostA----GE0/0--MSR-1--S1/0---------S1/0--MSR-2--GE0/0----HostB在两台路由器上的广域网接口分别作了如下配置:MSR-1:firewall enableacl number 3000rule 0 deny ip source 192.168.0.0 0.0.0.255rule 5 permit ipinterface Serial1/0link-protocol pppfirewall packet-filter 3000 outboundip address 6.6.6.2 255.255.255.0MSR-2:interface Serial1/0link-protocol pppip address 6.6.6.1 255.255.255.0假设HostA 的IP 地址为192.168.0.2/24,路由以及其他相关接口配置都正确,那么()。
第21题:
当学生A用两台Star—R2624路由器在做路由器广域网口连通实验时误将本端口路由器V.35线缆的插头插倒了。结果发现PING直连的路由器不通,请问此时需要查看路由器的状态应该是()
第22题:
Which line from the output of the show ip interface command indicates a layer 1 problem?()
第23题:
Serial0/1 is up, line protocol is down
Serial0/1 is down, line protocol is down
Serial0/1 is up, line protocol is up
Serial0/1 is administratively down, line protocol is down