单选题Companycom has a p690 and currently has eight LPARs. They have purchased a p5 590 and wish to migrate their eight LPARs to the new server. The LPARs are running either AIX 5.2 or AIX 5.3 with the current maintenance. What is the LEAST disruptive method

第1题：

Companycom has just purchased a p5 570 with AIX 5.3. The customer would like to add a training LPAR to the system, but no processors are available. All of the partitions are using dedicated resources. The test LPAR is using one processor and has a 90% CPU idle rate. What can be done to setup this training LPAR quickly without disabling their current environment?（）

• A、Use AIX 5.3 which supports micro-partitioning for both the test and training LPARS
• B、Use DLPAR to move resources from the test LPAR to training when training is active
• C、Install Partition Load Manager to share resources between the test and training environments
• D、Install Advanced Power Virtualization and then use micro-partitioning for both the test and  training LPARs

第2题：

Companycom is migrating from p670 systems running AIX 5.2 to p5 595 systems running AIX 5.3. They will be changing out only the system units. They will re-use the existing 61D drawers and adapters with the new p5 595 systems. What compatibility issue must be considered?（） 

• A、APV features are not supported for some legacy POWER4 adapters
• B、APV will require the most current maintenance level for AIX 5.2
• C、APV features will require that legacy POWER4 adapters be updated with new microcode
• D、The Virtual IO Server must run AIX 5.3 and the LPARs can run either AIX 5.2 or AIX 5.3

第3题：

Companycom is migrating their application that was built on AIX 4.3, to a new p5 590 system that is running AIX 5.3. The application was a 32-bit program. What will need to be done with the application to allow it to run on the new system?（）

• A、Run without recompiling on AIX 5.3
• B、Relink to the 32-bit kernel in order to run the application
• C、Recompile to run on AIX 5.3 because the libraries are in different locations
• D、Recompile 32-bit applications because the compiler flags and versions have changed

第4题：

Companycom has successfully established their p5 LPAR environment on a POWER5 p5 590 running AIX 5.2. They are now ready to move to Virtual IO. What would be required to do Virtual IO?（）

• A、Apply APAR IY62262 to the current AIX 5.2 Maintenance level 04. Virtual IO Server is not required. 
• B、Purchase Advanced POWER Virtualization software, upgrade to AIX 5.3 maintenance level 1 and apply APAR IY60349. Virtual IO Server is not required. 
• C、Verify that there are enough resources to add a Virtual IO Server, upgrade to AIX 5.3 with APAR IY60349, create a Virtual IO Server after applying APAR IY62262. 
• D、Verify that there are enough resources to add a Virtual IO Server, create a Virtual IO Server and apply APAR IY62262, verify that the system is at AIX 5.2 with Maintenance level 04.

第5题：

Companycom has a p5 595 running 12 LPARs. They are interested in high bandwidth, secure communication between two of the LPARs within the p5 595 server. They do not have any unused Ethernet adapters. Which of the following recommendations will best meet this requirement?（）

• A、Utilize the integrated 10/100/1000 network interface
• B、Implement Virtual Ethernet to enable inter-partition communication
• C、Implement shared Ethernet with the Ethernet adapters utilized in the other LPARs
• D、Implement a Point to Point protocol serial communication between the p5 595 serial ports

第6题：

第7题：

第8题：

第9题：

第10题：

第11题：

第12题：

第13题：

A customer has an 8-way p5-570 with eight internal disk drives and AIX 5.2.  Which of the following must be added， if anything， to the configuration to support four LPARs， assuming each LPAR requires twodisk drives？（）

• A、7311-D20 drawer with four disks
• B、Upgrade to AIX 5.3
• C、Fiber adapters to attach to SAN
• D、Nothing

第14题：

Companycom has seven days of vmstat data on a p5 590. The server has a total of four test/dev LPARs and 4 production LPARs of one processor each. On the four test/dev LPARs, the data shows 90-95% peak utilizations with a duration of from 5 to 10 minutes. The average utilizations of all LPARs were between 15-30%. All of the applications have different times when they peak.  What is the best configuration to fully utilize the processor resource?（）

• A、Set up the server in SMP mode and use WLM to manage resources effectively
• B、Set up eight dedicated LPARs and use DLPAR to manage resources effectively
• C、Set up a shared pool with eight capped LPARs including production and test/dev
• D、Set up a shared pool with eight uncapped LPARs with priority weight to Production

第15题：

Companycom has a p690 server with unused fiber (HBA) host bus adapters (feature code 6228) that they would like to reuse. They are interested in implementing Advanced Power Virtualization features particularly Virtual IO. What is the best way to proceed?（）

• A、Upgrade the p690 to a p5 590 server running AIX 5.3
• B、Upgrade the p690 server to AIX 5.3 and implement Advanced Power Virtualization
• C、Purchase a p5 590 with minimum resources and simply reuse the p690 unused fiber HBA adapters
• D、Purchase a p5 590 that has all the needed resources and adapters for Advanced Power Virtualization

第16题：

Companycom has a requirement for an LPAR in their p5 595 to run SUSE Linux. They also require an adapter that is not currently supported in Linux. Which of the following would be the best solution to recommend?（）

• A、Assign the adapter to an IO Hosting partition
• B、Use AIX 5L affinity to move the application from SUSE to AIX
• C、Use AIX 5.3 drivers to install the adapter in the Linux LPAR
• D、Assign the adapter to an AIX 5.3 partition running Linux Affinity

第17题：

第18题：

第19题：

第20题：

第21题：

第22题：

第23题：

第24题：